ADAPTER (CATALOG # BDCMTOA)

An accessory adapter kit is provided with BDCMTOA. The adapter is compatible with many manufacturers’ accessories, but if unsure, confirm with the specific manufacturer that their accessory is compatible.

CAUTION: To avoid injury, do not use any accessory for an application where the adaptor may fail to hold the accessory.

CAUTION: Read and follow all manufacturers’ safety warnings for any accessories used with this tool.

CAUTION: To avoid injury, ensure adapter and accessory are securely tightened.

CAUTION: Do not use this adaptor with Black and Decker accessories. Attach Black and Decker accessories with the accessory clamping lever (2) according to the instructions in this instruction manual.

To attach, place adapter plate (7) onto the oscillating tool attachment with protrusions facing up as shown in Figure E.

Place accessory and the adapter bolt and washer (8) on top of adapter and tighten with the hex wrench as shown in Figure F.

To remove, loosen the bolt and washer with the hex wrench and remove the accessory and adapter.

E

7

Protrusion

F

8

HELPFUL HINTS

• Always ensure the workpiece is firmly held or clamped to prevent movement. Any movement of the material may affect the quality of the cutting or sanding finish.

• Do not start sanding without having the sandpaper attached to sanding platen.

• Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces and fine grit for the finishing surfaces. If necessary, first make a test run on scrap material.

• Excessive force will reduce the working efficiency and cause motor overload. Replacing the accessory regularly will maintain optimum working efficiency.

• Do not allow the sandpaper to wear away, it will damage the sanding platen.

TROUBLESHOOTING

Problem

Possible Cause

Possible Solution

• Unit will not start.

• Attachment is not secured.

• Make certain the attachment is fully

 

 

pushed into the Power Unit.

For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.

NOTE: Refer to Power Unit instruction manual for troubleshooting solutions regarding opera- tion of the Power Unit.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service personnel, always using identical replacement parts.

ACCESSORIES

WARNING: The use of any accessory not recommended for use with this tool could be hazardous. Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: 1-800-544-6986.

7

Page 7
Image 7
Black & Decker BDCMTO Troubleshooting, Adapter Catalog # Bdcmtoa, Helpful Hints, Problem Possible Cause Possible Solution