Black & Decker BS600 manual Assembly, Installing the jug, Installing the lid and filler cap, Use

Assembly

•This appliance requires parts to be cleaned before use. See “Maintenance and Cleaning” for details.

Installing the jug

•Place the jug onto the motor unit, positioning the line moulded into the base of the handle with the unlocked padlock symbol on the motor base.

•Turn the jug clockwise until the line is positioned opposite the locked padlock symbol. Ensure that the motor unit and the jug are correctly assembled and securely locked in position.

Installing the lid and filler cap

•Line up the circle symbol on the lid with the unlocked padlock symbol on the jug.

•Lower the lid onto the jug, keeping the two symbols aligned,

•Turn the lid clockwise until the circle symbol lines up with the locked padlock symbol. Ensure that the lid and the jug are securely locked in position.

•To fit the filler cap, lower it onto the lid. Make sure the lugs on the filler cap fit between the two cut-out slots on the lid.

•Push the filler cap down to lock into position.

Installing the drip tray

•Slide the drip tray into the grooves on the motor base.

Use

•Remove the jug lid and place the ingredients inside the jug. For best results, ingredients should be cut into smaller pieces. Cut dry ingredients into smaller pieces before processing.

ENGLISH

•Replace the jug lid ensuring that the filler cap is installed.

•Fit the jug onto the motor base. Ensure the jug and the lid are fitted correctly, otherwise the smoothie maker will not work.

Warning! Make sure that the speed control dial is set to the off position ‘0’

before plugging the smoothie maker into the mains supply.

•Plug the motor unit into a suitable mains supply and switch on at the socket.

•To start, set the speed control dial to setting ‘1’. To increase the speed, turn the speed control dial clockwise.

Note: ‘1’ is the slowest speed setting and ‘3’ is the fastest.

•Alternatively, blend the ingredients in short bursts by turning and holding the speed control switch to the PULSE setting. Release it to stop.

Caution! Do not operate the unit continuously for more than one minute without a rest period of two minutes.

The filler cap can be carefully removed to feed ingredients into the jug during processing if required.

Warning! Do not place your fingers inside the jug when adding ingredients.

•Allow the ingredients to blend until smooth. When processing is complete, set the speed control dial to the off ‘0’ position. Switch off and unplug the blender from the mains supply.

5