ENGLISH

TROUBLE SHOOTING GUIDE

 

PROBLEM

SOLUTION

 

1.

Mower doesn’t run when switch lever is activated.

A. Check to make sure safety key has been installed and is

 

 

 

fully seated.

 

 

 

B. Ensure bail handle and switch lever are in “off” position.

 

 

 

Remove safety key, turn mower over and check that blade

 

 

 

is free to turn.

 

 

 

C. Has battery been fully charged? Plug in charger and wait

 

 

 

for green light to come on.

 

 

 

 

 

2.

Motor stops while mowing.

A. Ensure bail handle and switch lever are in “off” position.

 

 

 

Remove Safety Key. Turn mower over and check that blade

 

 

 

is free to turn.

 

 

 

B. Raise cutting height of wheels to highest position and start

 

 

 

mower.

 

 

 

C. Has battery been fully charged? Plug in charger and wait

 

 

 

for green light to come on.

 

 

 

D. Circuit breaker may have tripped. It resets automatically.

 

 

 

Re-set time could be as long as 1 minute. Slow down or

 

 

 

raise cut height.

 

 

 

 

 

3.

Mower runs but cutting performance is unsatisfactory,

A. Has battery been fully charged? (See Problem 1, Solution

 

 

or does not cut your entire lawn.

“C”.)

 

 

 

B. Ensure bail handle and switch lever are in “off” position.

 

 

 

Remove Safety Key. Turn mower over and check:

 

 

 

*Blade for sharpness

 

 

 

*Deck and discharge chute for clogging.

 

 

 

C. Wheel height adjustment may be set too low for grass

 

 

 

condition. Raise cutting height.

 

 

 

 

 

4.

Mower is too hard to push.

A. Raise cutting height to reduce deck drag on grass. Check

 

 

 

each wheel for free rotation.

 

 

 

 

 

5.

Mower is abnormally noisy and vibrates.

A. Ensure bail handle and switch lever are in “off” position.

 

 

 

Remove Safety Key. Turn mower on side and check blade

 

 

 

to ensure it has not been bent or damaged. If blade is

 

 

 

damaged, replace with a Black & Decker replacement

 

 

 

blade. If the underside of the deck is damaged return

 

 

 

mower to a Black & Decker Authorized service depot.

 

 

 

B. If there is no visible damage to the blade and the mower

 

 

 

still vibrates, return the mower to an authorized Black &

 

 

 

Decker service depot.

 

 

 

 

 

 

 

 

 

NOTE

Should the red light remain on after charging the battery for 24 hours on initial charge, the mower can still be used. The battery may need to be “conditioned” requiring a few battery charge and discharge cycles before the green indicator light comes on.

THIS IS ONLY A GUIDE INTENDED TO ENABLE YOU TO PERFORM VISUAL CHECKS AND SIMPLE TESTS. SHOULD NONE OF THE SOLUTIONS PROVIDE SATISFACTION OR IMPROVE PERFORMANCE CALL 1-800-762-6672 TO SPEAK TO A CONSUMER SERVICE REPRESENTATIVE OR TAKE THIS MOWER TO THE CLOSEST AUTHORIZED BLACK & DECKER SERVICE CENTRE FOR SERVICING.

10

Page 10
Image 10
Black & Decker CMM1000 instruction manual Trouble Shooting Guide, Problem Solution