Black & Decker CTL36 Adjusting The Wheel Height Position - Figure O, Using The Tiller

ADJUSTING THE WHEEL HEIGHT POSITION - (FIGURE O)

DANGER: Avoid accidental starting. Release bail handle to turn tiller O off, wait until the tines stop and remove safety key prior to adjusting wheel height position.

The Tiller has three wheel height positions.

Lowest Position - When the wheels are in their lowest position this will allow easy transportation to and from your work area.

Middle Position - In the middle position the wheels will be lifted up, but can still contact the ground. This may provide some users additional control and stability while tilling. It is recommended to raise or remove the drag bar when tilling in this wheel position.

Highest Position - In the highest position the wheels will not contact the ground. This position can be used for deep tilling.

1. To adjust the wheel height position, grasp the top of the mid handle (O-1)and lift slightly to raise the wheels off the ground.

2. Grasp the wheel height adjustment sleeve (O-2) under the wheel height adjustment knob (O-3) with your index and middle finger and slide up to release.

3. Move the knob to the desired detent position.

USING THE TILLER
1.	Move the tiller to the work area prior to starting the motor. Transport the tiller by pushing or pulling it along on its
2.	wheels with the safety key removed.
	Start the tiller following all steps under “ON-OFF SWITCH” on the previous page.
3.	With both hands on the upper handle, slowly pivot the tiller forward until the tines make contact with the soil.
4.	Once the tines are in the ground, till at a moderate pace until you are familiar with the controls and the handling of
5.	the tiller.
	To adjust the tilling depth, adjust the drag bar bracket and wheel height adjustment position as required.
6.	For deeper tilling move your tiller slowly back and forth. Work the same area over and over until the desired depth is
	reached.
CIRCUIT BREAKER - (FIGURE P)		P
The tiller is protected from overheating with a manually resettable circuit
breaker. It may require resetting if an overload condition existed.
1.	Remove the safety key from the tiller switch housing.
2.	Press the circuit breaker button (P-1)at the rear left side of the
3.	motor housing.
	Insert the safety key and restart tiller.
	NOTE: The tiller may need a few minutes to cool down. Pushing the
	breaker button back in will reset it.
UNJAMMING THE TINES - (FIGURE Q)		Q
	DANGER: Avoid accidental starting. Release bail handle to turn tiller
off, wait until the tines stop and remove safety key prior to unjamming tines.
To unjam the tines:
1.	Remove the safety key (Q-1)from the tiller switch housing.
2.	Insert the safety key into the tine unjam port (Q-2)as shown, push in
3.	on the key and turn clockwise.
	As the key is rotated, the tines will slowly rotate unjamming the debris.
4.	If the debris is not easily removed with the above operation, the tines
	may have to be removed.
	11