Black & Decker DE43 How to Use, Product may vary slightly from what is illustrated, Brewing, DE8

DE8Pub1000000664RV1 4/22/05 11:13 AM Page 4

Product may vary slightly from what is illustrated.

How to Use

This appliance is intended for household use only.

Getting Started

1. Remove all stickers, packing material, and literature.

Important: For warranty verification, please do not remove line cord sticker.

2.Wash all parts as instructed in the Care and Cleaning section.

3.Pour cold water up to 11-cup level mark in the water reservoir.

Brew it through as instructed in "BREWING", but do not add coffee grounds to the paper filter. When done, turn off the coffeemaker and discard the water from the carafe.

BREWING

1.Lift the one-piece cover. Use water markings on carafe to fill water reservoir with cold water.

2.Place a paper filter or the permanent gold-tone filter into the brew basket. Add ground coffee, (we recommend one heaping tablespoon for every 2 cups). Close the cover.

3.Place carafe on the "Keep Hot" plate and plug in the unit.

4.Press "ON/OFF" and the indicator light comes on, or, for delayed brewing (Clock Models), see "SETTING THE CLOCK/TIMER & AUTO-BREW". You don’t have to set the clock if you want to brew coffee right away.

5.Replace the carafe on the "Keep Hot" plate when not serving to keep coffee hot.

6.Press "ON/OFF" to turn off unit.

In models DE40 and DE43, coffeemaker will keep coffee warm for 2 hours before it automatically shuts off.

Sneak-A-Cup® Interrupt Feature

You can pour a cup of coffee while coffee is brewing without leaking from the brew basket. When finished pouring coffee, place the carafe under brew basket. The brewing process continues.

Important: To avoid possible overflow after removing the carafe, be sure to replace the carafe under the brew basket within one minute or less.

†1. One-piece cover (Part # DE43-01)

2.Water spreader

3.Water reservoir

4.Water windows (on both sides) with cup level markings

5.Cord storage (inside of unit)

6.Control panel (see models illus.)

7.“Keep Hot” plate

†8. 12-cup/60 oz. (1800 ml) carafe (Part # DE43-03 (W))

(Part # DE43-05 (B))

†9. Hinged carafe lid (Part # DE43-04 (W) (Part # DE43-06 (B))

†10. Removable brew basket (Part # DE43-02)

11. Guide

†12. Permanent gold-tone filter (certain models) (Part #175543-00)

† Consumer replaceable

SETTING THE CLOCK/TIMER & AUTO-BREW (For Clock Models)

Plug in unit, clock flashes 12:00 a.m. until correct time is set. The coffeemaker works without setting the clock.

1. To set current time of day: Press the HOUR button, little dot in the top left corner of the

display indicates "p.m." time. Press the MIN button. Clock momentarily flashes the time

just set. Once set, clock continues to keep time unless coffeemaker is unplugged or a

power failure occurs. To reset, press SET button and reset current time. Clock can only

be reset when in the flashing mode.

2. To set the Auto Brew time: Press the PROG button and the light near the AUTO button

starts flashing indicating it is being programmed. Press the HOUR, then MIN buttons to set

the time you’d like coffee to automatically begin brewing (for example 7:15 a.m.). Watch

for the "p.m." indicator dot at the top left of the digital display. When finished, press the

AUTO button. The AUTO light will stop flashing and will stay on to show the timer is

activated.

CONTROL PANELS

DE8 DE40, DE43

3.	Prepare the coffeemaker for brewing as instructed in "BREWING" but don’t turn
	on the unit.
4.	To check your pre-set auto time, press PROG and it will display. When the clock returns
	to the current time of day, press AUTO to reactivate the timer. To automatically brew
	coffee again at the same pre-set auto-on time, prepare coffeemaker for brewing again
	and press the AUTO button.

Note: The Auto Brew function can be canceled at any time by pressing the AUTO button a second time. The AUTO light goes out.

3 4