Black & Decker DE755B How to Use, Product may vary slightly from what is illustrated, Brewing

Product may vary slightly from what is illustrated.

†1. One piece water reservoir and brew basket lid (Part # DE755B-03)

2.Water spreader

3.Guide

4.Water reservoir

5.Water level window

6.Control Panel

7.“Keep Hot” plate

†8. 12-cup/60 oz. (1774 ml) carafe with lid (Part # DE755B-02)

†9. Removable brew basket (Part #DE755B-01)

†10. Permanent gold-tone filter (Part # PF75) †Consumer replaceable/removable parts

CONTROL PANEL

How to Use

This appliance is intended for household use only.

Getting Started

1.Remove all stickers, packing material, and literature.

2.Wash all parts as instructed in the Care and Cleaning section.

3.Pour water up to 12-cup level mark in the water reservoir.

Brew it through as instructed in "BREWING", but do not add coffee grounds to the permanent filter. When done, turn off the coffeemaker and discard the water from the carafe.

BREWING

1.Lift one piece water reservoir and brew basket lid. Use water markings on carafe to fill water reservoir with water.

2.Place the permanent gold-tone filter into the brew basket. Add ground coffee, (we recommend a heaping tablespoon for every cup). Close the cover. Make sure permanent gold-tone filter is secured in place.

3.Place carafe on the "Keep Hot" plate and plug in the unit.

4.Press "ON/OFF" and the indicator light located on the right corner of the control panel will turn on. For delayed brewing, see "SETTING THE CLOCK/TIMER & AUTO-BREW". You don’t have to set the clock if you want to brew coffee right away.

5.Replace the carafe on the "Keep Hot" plate when not serving to keep coffee hot.

6.Press "ON/OFF" to turn off unit.

The coffeemaker will keep coffee warm for 2 hours before it automatically shuts off.

Sneak-A-Cup® Interrupt Feature

You can pour a cup of coffee while coffee is brewing without leaking from the brew basket. When finished pouring coffee, place the carafe under brew basket. The brewing process continues.

Important: To avoid possible overflow after removing the carafe, be sure to replace the carafe under the brew basket within 30 seconds or less.

SETTING THE CLOCK/TIMER & AUTO-BREW

Plug in unit, clock flashes 12:00 a.m. until correct time is set. The coffeemaker works without setting the clock.

1.To set current time of day: Press the HOUR button, little dot in the top left corner of the display indicates "p.m." time. Press the MIN button. Once set, clock continues to keep time unless coffeemaker is unplugged or a power failure occurs. To reset, press either the hour or minutes until desired time is reached.

2.To set the Auto Brew time: Press the PROG button and the light in the upper right corner of the display button starts flashing, indicating it is being programmed. Press the HOUR, then MIN buttons to set the time you’d like coffee to automatically begin brewing (for example 7:15 a.m.). Watch for the "p.m." indicator dot at the top left of the digital display. When finished, press the AUTO button. The AUTO light will stop flashing and will stay on to show the timer is activated.

3.Prepare the coffeemaker for brewing as instructed in "BREWING" but don’t turn on the unit.

4.To check your pre-set auto time, press PROG and it will display. When the clock returns to the current time of day, press AUTO to reactivate the timer. To automatically brew coffee again at the same pre-set auto-on time, prepare coffeemaker for brewing again and press the AUTO button.

Note: The Auto Brew function can be canceled at any time by pressing the AUTO button a second time. The AUTO light goes out. After 2 hours , coffeemaker will automatically shut off.

3 4