Product may vary slightly from what is illustrated.
CONTROLS |
B |
The controls are located on the front of the base (B). Press PULSE, HIGH or LOW to select a function (see directions below).
OFF/PULSE
•Processor should be stored in OFF position and unplugged when not in use.
•Use PULSE for short processing tasks. This lets you control the size and uniformity of foods being chopped.
ENGLISH
• The OFF/PULSE button must be pressed and held for the appliance to |
operate in PULSE mode. When released, the appliance will stop. |
• The motor of the processor will run as long as the OFF/PULSE button is |
held down. Press the button and then release to allow the blades to stop |
A
†1. Food pusher (Part # 07234DZ118 [white] / 07234EZB [black])
†2.
†3.
†4. Reversible slice/shred disc (Part #
†5. Storage lid (Model FP2500S) (Part # 07239GZ4)
†6. Dough blade (Part # 77840)
†7. Large, stainless steel chopping blade (Part # 77793)
†8. Disc stem (Part # 77789)
†9.
(Part # 77841(Only for Models FP2500B/FP2500S) Part #77842 (Only for Model FP2500)
10.Base
11.Cord wrap (under base)
†12.
13.Controls
Note: † indicates consumer replaceable/removable parts
running and the food to fall to the bottom of the workbowl. |
• Pulsing gives better control when chopping, mincing, mixing and blending |
foods. You can control the size of the foods, from coarse to fine. |
HIGH and LOW
When either speed is selected, the processor will run continuously until the OFF/PULSE button is pressed.
How to Use
This product is for household use only.
•Remove all packing material and any stickers from the product.
•Please go to www.prodprotect.com/applica to register your warranty.
Important: Handle chopping blades and slice/shred disc carefully. They are very sharp.
•Wash all removable parts as instructed in CARE AND CLEANING section of this manual.
•Select a level, dry countertop where the appliance is to be used, allowing air space on all sides to provide proper ventilation for the motor.
ASSEMBLING THE PROCESSOR
How to Insert and Remove the Center Post:
The center posts of both bowls are removable:
1. Turn the bowl upside down.
2. Grasp the clear outer tabs and turn the center post clockwise until the lower tabs are free. Lift the post out
(C).
3.To return to its original position, place center post into smaller opening in bottom of workbowl and turn counterclockwise until tabs snap into place.
C
