PS400JRB_Manual EN_090506 SE.qxp 9/6/06 3:38 PM Page 11
AC POWER SUPPLY CONTROLS AND INDICATORS
The illustration below details the AC Power Supply front panel. Air vents keep the unit from overheating. An On/Off switch turns the AC power circuitry on and off. The ON/OFF switch can also be used to reset the AC power after shutdown due to overvoltage, overload or over- temperature condition. The “On” status indicator lights when the AC power supply is on. The AC outlets (covered when not in use) supply power to AC appliances.
AC Power Supply Front Panel
AC POWER SUPPLY |
|
| AC POWER SUPPLY | |
“ON” STATUS |
|
| ON/OFF SWITCH | |
INDICATOR |
|
|
| |
|
|
|
| 120 VOLT AC |
AIR VENTS |
|
|
| OUTLETS |
|
|
|
| |
|
|
|
|
|
AC Power Supply Operation
1.Turn power switch to on (the power indicator lights).
2.Plug in appliance and turn the appliance on.
Note: The AC power supply shuts down automatically when the battery voltage level is too low. If the green LED flashes, a faulty condition such as an overload, overheating or short circuiting has occurred. Turn the AC Power Supply off and unplug the appliance. Wait a few minutes, then turn power back on.
USING THE EMERGENCY AREA LIGHT
The Area Light is controlled by an ON/OFF pushbutton. Make sure the light is turned OFF when the unit is being recharged or stored.
OPERATING THE AM/FM RADIO
See page 6 to locate referenced controls, knobs and selectors.
•Slide the OFF/AM/FM/Weather Selector to the desired frequency (the AM or FM position).
•Turn the Radio Tuner Knob to select the desired station.
•Extend the
•Adjust the volume using the Volume Control Knob.
•To turn the Radio OFF, simply slide the OFF/AM/FM/Weather Selector to the OFF position.
OPERATING THE WEATHER RADIO
•Slide the OFF/AM/FM/Weather Selector to the Weather band position.
•With the ALERT ON/OFF Pushbutton OFF, turn the Radio Tuner Knob to select the NOAA station with the strongest signal.
•Extend the
•Adjust the volume using the Volume Control Knob.
•Press the Alert Pushbutton to turn the Alert feature ON (the Alert LED will light) and press the ALARM/LOCK Pushbutton to set it in lock position (the Alarm Lock LED will light) for Alert standby mode. Note that the speaker is muted while Radio monitors for a hazard alert.
•To turn the Radio OFF, simply slide the OFF/AM/FM/Weather Selector to the OFF position.
11
