Black & Decker PV1225NB, PV1825N, PV1225NPM, PV1425N manual Assembly, Use

Electrical safety

Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate.

If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.

Warning! Never attempt to replace the charger unit with a regular mains plug.

Symbols on the charging base

Your charging base is double insulated; therefore no earth wire is required.

Safety isolating transformer. The mains supply is electrically separated from the transformer output.

The charging base is intended for indoor use only.

Features

1.Dust collector

2.Dust container release button

3.Pivot lock button

4.On/off switch

5.Container door

6.Container door release latch

7.Charging base

8.Flip-out brush

9.Dust collector extension

Assembly

Adjusting the dust collector (fig. A - C)

The dust collector (1) has a brush that can be folded forward for dusting and upholstery cleaning.

The dust collector (1) is stored under the appliance. To adjust for use, lift the appliance from the charging base (7).

Press the pivot lock button (3) and rotate the dust collector (1) to the required position.

Release the pivot lock button (3) to lock the dust collector in position.

The dust collector can be extended by pulling the dust collector extension (9) until it locks into position.

The extension can be retracted by pressing the button (10) and pushing the extension back into the dust collector.

ENGLISH

The dust collector should be returned to the storage position under the appliance after use and while charging the appliance.

Residual risks

Additional residual risks may arise when using the tool which may not be included in the enclosed safety warnings. These risks can arise from misuse, prolonged use etc.

Even with the application of the relevant safety regulations and the implementation of safety devices, certain residual risks cannot be avoided. These include:

Injuries caused by touching any rotating/moving parts.

Injuries caused when changing any parts, blades or accessories.

Injuries caused by prolonged use of a tool. When using any tool for prolonged periods make sure you take regular breaks.

Impairment of hearing.

Health hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF).

Use

Before first use, the battery must be charged for at least 24 hours.

Place the appliance on the charging base whenever it is not in use.

Charging the battery (fig. D)

Make sure that the appliance is switched off. The battery will not be charged with the on/off switch (4) in the on position.

Place the appliance on the charging base (7) as shown.

Plug in the charger. Switch on at the mains.

The charging indicator will be lit.

Leave the appliance to charge for at least 24 hours.

While charging, the charger may become warm. This is normal and does not indicate a problem. The appliance can be left connected to the charger indefinitely. The charging indicator will be lit as long as the appliance is connected to the plugged-in charger.

Warning! Do not charge the battery at ambient temperatures below 4 °C or above 40 °C.

Switching on and off (fig. E)

To switch the appliance on, slide the on/off switch (4) forward to position I.

To switch the appliance off, slide the on/off switch (4) back to position 0.

7