TROUBLESHOOTING GUIDE - continued
Symptom
Cause
Solution
Spray wand or | Broken | Contact B&D Customer Service | |
extension leaks. |
| Representative at | |
Pump is excessively | Pump is sucking air. | Check that hoses and fittings are air | |
noisy. |
| tight. Turn off machine and purge | |
|
| pump by squeezing trigger gun until a | |
|
| steady flow of water emerges from the | |
|
| nozzle. | |
Water leaks from | Loose fittings. | Check that all fittings are tight. | |
pump. | Water seals are damaged | Contact B&D Customer Service | |
| or worn. | Representative at | |
Oil leak. | Oil seals are damaged or | Contact B&D Customer Service | |
| worn. | Representative at | |
Motor buzzes but | Supply voltage below | Verify that only the pressure washer is | |
fails to run. | minimum. | running on this circuit. | |
| System has residual | Turn unit off, squeeze trigger on spray | |
| pressure. | wand to release pressure, then turn | |
|
| unit on. | |
| Voltage loss due to | Do not use extension cord with this | |
| extension cord. | unit - plug directly into outlet. | |
| Cleaner not used for long | Contact B&D Customer Service | |
| periods. | Representative at | |
|
|
|
10
