598111-01,PW1300 manual 1/31/05 1:51 PM Page 7

NOTE: DO NOT USE:

Bleach, chlorine products and other corrosive chemicals.

Liquids containing solvents (i.e., paint thinners, gasoline, oils)

Tri-sodium phosphate products

Ammonia products

Acid-based products

These chemicals will harm the unit and will damage the surface being cleaned.

SURFACE PREPARATION

Before starting any cleaning task it is important to inspect the area for objects which could create a hazard. Remove objects from the area which could be tripped over such as children's toys or outdoor furniture. Insure that all doors and windows are closed tight. Also make sure that all plants and trees in the adjacent area are protected by a drop cloth ensuring that they will not be harmed by any overspray.

GENERAL CLEANING TIPS

Remove the spray wand from the gun as shown in Figure G. Remove any dirt from the spray wand nozzle hole and rinse.

G

For cleaning tasks such as deck or brick patio cleaning, limit your work area to approximately 25 square feet at a time.

Pre-rinse cleaning area with fresh water.

Use only detergents formulated for pressure washers.

Always test detergent in an inconspicuous area before use.

Begin with a wide fan nozzle spray and adjust the pressure to the desired spray pattern.

The best angle for spraying water against a cleaning surface is 45 degrees. Spraying head on tends to cause dirt

particles to imbed in the surface. When working on vertical surfaces, it is best to apply detergent starting at the bottom and working upwards which will prevent the detergent from sliding down and causing streaks.

SHUTDOWN

1.Depress the off switch and unplug the cord from the outlet.

2.Turn off water at the faucet.

3.Discharge residual pressure by pressing the trigger until no more water comes out of the adjustable nozzle.

4.Engage the gun safety catch.

5.Disconnect the garden hose from the water inlet.

6.Disconnect the high pressure hose from the high pressure outlet and drain hose.

STORAGE

1.Store pressure washer indoors away from areas that might freeze.

2.Do not allow high pressure hose to become kinked.

3.Turn unit on for a few seconds until all water is removed from the pump. Turn off immediately.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. CAUTION: Never use the pressure washer to clean itself.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service personnel, always using identical replacement parts.

ACCESSORIES

Recommended accessories for use with your pressure washer are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: 1-800-544-6986.

WARNING: The use of any accessory not recommended for use with this pressure washer could be hazardous.

7

Page 7
Image 7
Black & Decker 598111-01, PW1300 Surface Preparation, General Cleaning Tips, Shutdown, Storage, Maintenance