598111-01,PW1300 manual 1/31/05 1:51 PM Page 5

5

CAUTION: The pressure washer must only be used with clean water; use of unfiltered water or corrosive chemicals will damage the pressure washer.

OPERATION

NOTE: Before cleaning any surface, an inconspicuous area should be cleaned to test spray pattern and distance for maximum cleaning results. If painted surfaces are peeling or chipping, use extreme caution as pressure washer may remove the loose paint from the surface.

The PW1300 Pressure Washer is equipped with automatic delivery flow cut-off:

When the trigger is released, the dynamic pressure automatically cuts out the motor.

When the trigger is pressed the pressure drop automatically starts the motor and the pressure is restored with a very slight delay.

Figure 6 - Plug the Ground Fault

Circuit Interrupter (GFCI) (F) into a working grounded outlet. TEST BEFORE EACH USE. The indicator at the top of the GFCI should turn red when product is ready to use. Press the “TEST” button (bottom). The red indicator should disappear. Press “RESET” button for use. Do not use if the above test fails.

6

Figure 7 - Release the safety catch shown in Figure 7, by pressing down on the latch behind the trigger, or by pushing the trigger forward, then press the trigger for a few seconds to allow air to escape and to discharge residual pressure in the hoses.

7

Figure 8 - Turn on the pressure washer by depressing the bottom half of the switch (H) marked “I”. The unit will run for a few seconds as it builds up pressure, then will shut off. It will run on demand as the gun trigger is depressed. Turn off the pressure washer by depressing the top half of the switch marked “0”.

8

5

Page 5
Image 5
Black & Decker 598111-01, PW1300 instruction manual Operation