YOUR PRESSURE WASHER IS NOW READY TO USE - PLEASE REVIEW THE FOLLOWING FOR DETAILS ON ACCESSORIES APPLICATION.
ACCESSORIES
CAUTION: Before changing accessories, turn unit off, pull trigger to release pressure, and activate safety catch.
•ADJUSTABLE FAN WAND
1.) Insert the fan wand (D) into the gun wand (E) by pushing and rotating until the two parts are locked as shown in Figure A.
A |
2.) To obtain maximum pressure, rotate the fan wand nozzle in a clockwise direction as shown in FIgure B. This narrow stream results in deeper cleaning in a concentrated area. For a wider fan pattern rotate the fan wand nozzle in the counterclockwise direction. The wider fan pattern reduces the risk of surface damage and allows for cleaning large surface areas quickly.
B |
3.) To remove, press wand into gun and twist as shown in Figure C.
C |
•TURBO NOZZLE
1.) Insert the turbo nozzle (C) into the gun wand (E) by pushing and rotating until the two parts are locked as shown in Figure D.
D |
2.) There is no adjustment required with the turbo nozzle.
3.) To remove, press nozzle into gun and twist as shown in Figure E.
E |
•DETERGENT APPLICATOR
Follow manufacturer’s label directions for mixing correct concentrations of soap and detergents.
To use the applicator:
1.) Unscrew top of detergent applicator
(G)and fill with detergent.
2.) Replace top.
3.) Insert detergent applicator (G) into gun wand (E). Twist detergent bottle until it clicks firmly into place as shown in Figure F.
F |
4.) Apply detergent from the bottom to the top to prevent detergent from sliding down and streaking.
5.) Leave detergent on the surface for a few minutes but do not allow it to begin to dry.
6.) Remove detergent applicator from the gun wand by turning the detergent bottle 1/4 turn and pulling straight out.
7.) Rinse detergent from surface.
8.) Flush detergent applicator with clean water.
6
