Black & Decker PW1700SPM Adjustment information fig.3, Information on use of the appliance fig.4

Adjustment information (fig.3)

Adjusting the spray nozzle (for models with this feature)

•Water flow is adjusted by regulating the nozzle (E).

Adjusting the detergent (on models with this feature)

•Detergent flow is adjusted using the regulator (F).

Adjusting the detergent pressure

Set the adjustable nozzle (E) on " - " to deliver detergent at the correct pressure (on models with this feature).

Adjusting the pressure (on models with this feature)

•The regulator (G) is used to adjust the working pressure. The pressure is shown on the pressure gauge (where fitted).

Information on use of the appliance (fig.4)

Controls

•Starter device (H).

Set the starter switch on (ON/1) to:

a)Start the motor (in models without TSS device);

b)Set the motor ready to start (in models with TSS device).

•If there is a pilot light on the starter device, it should light up.

•If the “low/high” settings are available, use them as follows:

•Low : low pressure washing

•High : high pressure washing

•Set the starter device switch on (OFF/0) to shut down the appliance.

•If there is a pilot light on the starter device, it should go out.

•Water jet control lever (I).

Caution - Danger!

During operation the appliance must be positioned as shown in fig. 4 on a sturdy, stable surface.

ENGLISH

Start-up

1)Turn on the water supply tap fully.

2)Release the safety catch (D).

3)Depress the gun trigger for a few seconds and start up the appliance using the starter device (ON/1).

Caution - Danger!

Before starting up the appliance check that the water supply hose is connected properly; use of the appliance without water will damage it; do not cover the ventilation grilles when the appliance is in use.

TSS models - In TSS models with automatic delivery flow cut-off system:

•When the gun trigger is released the dynamic pressure automatically cuts out the motor (see fig.4);

•When the gun trigger is depressed the automatic drop in pressure starts the motor and the pressure is restored after a very slight delay;

•If the TSS is to function correctly all gun releasing and depressing operations must be performed at intervals of not less than 4-5 seconds at least.

•On three-phase models for professional use, at first use start the appliance for a very short time to check that the motor is running in the correct direction. If the motor fan is turning anti-clockwise, exchange two of the three phase wires (L1, L2, L3) in the electrical plug.

•To prevent damage to the appliance, do not allow it to operate dry and when running do not stop the water jet for more than 10 minutes at a time (for models without TSS device).

Stopping the appliance

1)Set the starter device switch on (OFF/0).

2)Depress the gun trigger and discharge the residual pressure inside the hoses.

3)Engage the gun safety catch (D).

Restarting

1)Release the safety catch (D).

2)Depress the gun trigger and discharge the residual air inside the hoses.

3)Set the starter device on (ON/1).

9