AC211A-R2 & AC216A-R2

Chapter 6 : REMOTE CONTROL SOFTWARE

Your device is shipped with a Windows compatible Remote Control Software. This software allows you to control and make all adjustments by a simple mouse click.

NOTE: The latest Remote Control Software is available on our web site: www.analogway.com 6-1. CONNECTIONS

cCONNECTING TO THE RS-232 PORT:

-Connect the serial port of your control device to the RS-232port (DB9 Female connector) of the device with a straight cable (DB9 Female / DB9 Male).

-Speed transmission: 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.

-Pin-out:

PIN #

FUNCTIONS

2TRANSMIT DATA (Tx)

3RECEIVE DATA (Rx)

5

GROUND (Gnd)

DB9 female (Rear panel of the device)

6-2. SOFTWARE INSTALLATION

cTurn your computer ON and wait for Windows to completely start.

dInsert the CD-ROM into your drive: the home window will open automatically.

eSelect the language of the CD-ROM menus, then click on "Install a Remote Control Software" and select the name of your device.

IMPORTANT: If the Autorun is not enabled: From the Windows desktop, open My Computer and select the CD-

ROM drive. Select the Autorun folder, then select the autorun.exe file.

fFollow the Windows installation instructions.

6-3. COMMUNICATION SETUP

cConnect the RS-232 or RJ45 cable between the device and the control device as indicated in the section 6-1. d Then only power ON all of the devices.

e Click on the program files AC216 in Start>program>BLACK BOX>AC216 to run the software.

f Click on Controls menu and select the COM port number corresponding to the connection of the device.

When the communication is established, the message "Device connected" is displayed.

PAGE 22