ServSwitch Freedom
4.4 | (Windows only) |
4.4.1 Installing drivers and multi-monitor config app
In order to use
1.On each multiple monitor PC, run the downloaded file. After accepting the licence agreement you will be prompted to choose a destination folder. Either accept the suggested location or change it, as necessary.
Note: The Install for all users option should be ticked if there are more than one user account on the PC and all need to use Glide and Switch.
2.The options available during installation are as follows:
•Full Install, (this is recommended), or
•Options to install individually:
•Configuration App.
This is the Glide and Switch application and needs to be installed only on the PC that will be used to set up the ServSwitch Freedom switch via the supplied flash upgrade cable and OPTIONS port.
•Visual C++ Runtime
The C++ runtime library is a windows component that is required by the
•Drivers.
Choose the required components and click the Next > button.
3.Once the chosen components have been installed, click the Finish button.
Note: On the PC that will be used to set up the ServSwitch Freedom switch, you can optionally tick ‘Click to run the Glide and Switch Configuration Application’ in the lower left corner to immediately begin using Glide and Switch - see 4.5 Configuring multiple monitors opposite for details.
Note: On each PC that you installed the driver, a process called mumoapp.exe will remain running.
Page 26 |