Black Box LE3700A-R2 manual Print Server Screen

ETHERNET PRINT SERVER

After the EPS loads the Flash code and the unit is running normally, the OK LED will blink once each 2 seconds. Depending on SW2’s position, the EPS will print a greeting to the serial port when the unit is operational:

Ethernet Address: xx-xx-xx-xx-xx-xx IP Address: undefined

Lantronix EPS1 Print Server

Diagnostics Report:
Interface:	10BASE-T
Memory:	256KB
Gate Array:	Vers 3
Errors Reported: None
Attempting BOOTP: no reply received.
Attempting RARP: no reply received.
Checking 2 sections from flash:
From address .... -> not copied.
From address
Loaded 310260 bytes.
Load Completed - Boot in Progress
[10 lines of PostScript comments]
Lantronix EPS1 Print Server
Ethernet Address: xx-xx-xx-xx-xx-xx		IP Address:
undefined

Fig. 3-2. Print Server Screen.

The server is now running normally. It will set the IP address if discovered via BOOTP or RARP (or previously DEFINEd on the EPS). If the screen shown in Fig. 3-2 does not appear, see Troubleshooting, Section 4.6. If garbled characters appear on the console, check the terminal settings and the serial cable and cycle power to the server.

When the screen in Fig. 3-2 appears, you can try to log into the EPS. Press <Return> on the console and you will get a “Username>” prompt. Enter any username and press <Return>. You will then be at the “Local>” prompt, and can type “HELP” to get a list of EPS commands. See Section 4.0, Host Configuration, or log out and attach your serial print device to the console port. Remember to change SW2 to the On position if you will only attach a print device to the serial port. Otherwise, the EPS will echo boot diagnostics to the printer.

14