2.0 Quick Start
2.4.7
The
•The modem must be configured for use with a
•Operation is restricted to data rates of 4800, 7200, and 9600 bps.
•Lines can be conditioned or unconditioned.
After you select this Quick Setup mode, the modem will send a training sequence and wait for a training response from the remote modem. The modem will repeat the training sequence every 1.2 seconds until the remote modem responds.
When the local modem has established a connection with the remote unit, the TIE/EIA status screen will appear.
NOTE
For
V.34/V.32 Dial Backup
NOTE
Dial backup can only be used in
To prevent service interruption in the event of poor leased line conditions, the modem can be configured for V.29 leased line operation with V.34/V.32 dial backup. This means the modem will use dial lines to automatically restore operation when conditions on the leased lines deteriorate. (Use V.34 or V.32 modulation for dial backup.) To set up the Modem for V.29 leased line operation with dial backup, follow these steps:
1)Select the
2)One modem must be set to originate mode and the other to answer mode. To make this selection, use the ANS/ORG DEFAULT screen on the front panel LCD.
3)Configure the modems for leased line
23