20
PQ-8P, PQ-8S
4. Configuration
2.Make sure the PQ-8 is properly
connected to the twinax host
and the correct device address
is set.
3.Power on the PQ-8. The AS/400
will auto-configure the printer
address according to the PQ-8
settings.
If you are using an S/3X host, you
must configure the host manually.
Table 4-1 shows the recommended
emulation and device ID for the
different host systems.

4.1 Host Configuration

Before operating the PQ-8 in twinax
mode, the IBM host must be
configured with a device address and
device ID for the printer. See your
system operator or system manual
for details. With the correct address
selected, an AS/400 will
automatically configure itself
according to the active IBM printer
emulation on the PQ-8.
1.Make sure you have selected and
permanently stored the desired
IBM emulation on the PQ-8.
This can be done through the
setup software or Host/PC
download command Z24 (to
select emulation) followed by
command Z99,0 (to save).