Blaupunkt CD33 Troubleshooting Guide Specifications, General, Radio reception

Troubleshooting Guide Specifications

The following check will assist in the correction of most prob- lems which you may encounter with your unit. Before going through the check list below, refer back to the connection and operating procedures.

General

	Trouble	Cause/Solution
•	Memorized stations and	Leads are not matched
	correct time are erased.	correctly with the car’s
•	The fuse has blown.	accessory power
•	Radio works when the igni-	connector.
	tion key is the ON, ACC and	Check wiring for short
	OFF positions.	circuits.
•	No power is being supplied
	to the unit.
• The power is continuously		The car doesn't have an
	supplied to the unit.	ACC position.

Radio reception

Trouble	Cause/Solution
Preset stations are not re-	The broadcast signal is too
ceivable.	weak.
Seek tuning is not possible	The broadcast signal is too
	weak. → Use manual tuning.
Travel Store feature does	Not enough broadcast frequen-
not complete storing of six	cies are receivable.
stations.

Also make sure that antenna is connected, extended and dry inside.

If the above mentioned solutions do not help to improve the situation, consult your nearest Blaupunkt dealer or in the United States call 1-800-266-2528 for technical assistance, parts and service. Call 1-800-950-2528 for dealer referral or to request product brochure.

CD Player Troubleshooting

When problems occur with CD playback, an error message appears in the display window.

Refer to the table below to identify the problem, then take the suggested corrective action. If the error persists, contact your nearest Blaupunkt dealer.

Message	Possible cause	Recommended action
FOCUS	Dirty disc.	Clean the disc.
ERR	Scrached disc.	Replace the disc.
	Up-side-down.	Check the disc.
SERVO	Data and focus error.Eject and re-insert.
ERR
MECHA	Mchanical problem.	Eject and re-insert.
ERR
TOC ERR	The disc cannot	Eject and re-insert. In-
	read properly.	sert anothert disc.
DATA	Plays the data track	You can not play a CD-
TRACK	of MIX mode CD or	ROM. Skip the music
	CD-ROM.	track with TUN/TRK dial.

CD Changer Troubleshooting

When problems should develop while operating CD changer, an error message appears in the display window.

Refer to the table below to identify the problem, then take the suggested corrective action. If the error persists or “MECHA ERR” and “09 ERROR” appears, contact your nearest

Blaupunkt dealer.

Message	Possible cause	Recommended action
NO MAG	No magazine.	Load the magazine in
NO DISC	No disc.	the CD changer.
		Check the disc.
CD ERR	Up-side-down.	Check the disc.
	Focus error.
COMM ERR	Communication error. Check the connection of
		the CD changer.
TEMP ERR	Excessive tempera-	The error sign will go off
	ture conditions at	and play will resume
	the CD changer.	when the temperature to
		a normal range.

GENERAL
Dimensions	: Approx. 178 mm ⋅ 50 mm ⋅ 155 mm			ENGLISH
		(188watts)
		(W ⋅ H ⋅ D) *excluding Front panel.
Power requirements :		12 volts DC car battery
		(negative ground)
Output Power	: RMS and Peak Power		ratings
		220 watts /55 peak ⋅ 4 ch
Output Wiring	: Floating-ground type designed for 4
		speaker use.
		RCA low-level outputs (2 channels).
Output Impedance	: Compatible with 4-8 ohm speakers.
Low - Level Output	:	2 V.

TUNER

Tuning Range	: AM		:	530 - 1,710 kHz (10 kHz step)
		FM	: 87.5 - 107.9 MHz (200 kHz step)
Sensitivity	: AM		:	20 µV
		FM	:	9.1 dBf mono sensitivity
FM
Stereo Separation	:	35 dB
CD PLAYER
Frequency
Response	:	20 - 20,000 Hz
S/N Ratio	:	98 dB
Wow & Flutter	: Below the measurable limit
OTHER
Remote Control options :			RC-823 Credit Card Remote
CD Changer cable		:	p/n F00E500029
AUX input cable		:	p/n 7 607 897 093

E-15

SacramentoCD33_Eng 15 2/5/03, 4:28 PM