General Operations
Turning the power On/Off
Press the PWR to turn the unit On or Off.
Tip
When you turn on the unit, “HELLO” will be displayed then “WELCOME” will momentarily be displayed before actual power on.
When you turn off the unit, “SEE YOU” will be displayed then
You can edit these messages. (See “Turn on/off message edit”).
Volume Control
Rotate the VOL dial to adjust the volume.
Volume up | + |
|
VOL
Volume down
-
Muting the sound
Press .
To restore the previous volume level, pressagain.
Notes
• If the | CD | button is pressed when no CD has been loaded |
|
into the unit, The CD mode will skip to the CD changer mode or AUX mode.
Also, if the CD changer is not connected, the system will move across to the AUX mode regardless of whether auxil- iary equipment is connected or not (“ AUX ” will be dis- played.)
•It is not possible to switch to the AUX mode when the CD changer is connected.
Setting the Clock
The clock uses a
1. Turn the ignition key to the ON position.
2. Press the PWR to turn on the unit.
3. Repeatedly press the DISP to display “CLK ADJ.
4. Use the following buttons and dial to set the clock. (The blink- ing section can be adjusted.)
SC/PS | : To switch Hour/Minute blink |
Adjusting the Sound Characteristics | ENGLISH | |
2. Rotate the VOL dial to adjust the selected item. | ||
1. | Each time you press the AUDIO to select the desired ad- |
|
| justment mode as table below. |
|
| After pressing the AUDIO , you can also select with TUN/ |
|
| TRK dial or DISP . |
|
| Use the following tables as a guide for adjusting the set- |
|
| tings in each mode. |
|
| Adjust within 5 seconds after selecting the item. After 5 |
|
| seconds, the unit returns to previous indication. |
|
+
VOL
-
Adjustment Range
bAS B 0 (BASS) | B | ~ | B 0 | ~ | B +5 |
TRE T 0 (TREBLE) | T | ~ | T 0 | ~ | T +5 |
Ld LOUD | LOUD OFF | – |
| LOUD ON | |
bAS |
| ~ |
| ||
bAL B 0 (BALANCE) | B L9 | ~ | B 0 | ~ | B R9 |
Mute level can be adjustable. (See “Adjusting the Sound Characteristics”)
+
VOL
-
: Adjust the Hour and minute
FAd F 0 (FADER) | F R9 | ~ | F 0 | ~ | F F9 |
AU GAIN | ~ | 0 | ~ | 3 | |
LMt LEVEL | 0 | ~ | 50 | ~ | 80 |
Switching the Source (Selecting auxiliary input)
You can connect auxiliary equipment (Portable cassette player, etc) to this radio via optional
Each time the |
| CD | is pressed, the operation source will | |
|
| |||
change over as shown below; | ||||
RADIO | CD CD changer or AUX | |||
|
|
|
|
|
Press the BAND | to return to tuner mode. |
5. Press the DISP momentarily to complete the Clock set- ting mode.
Ignition-off Clock Recall
The display will illuminate showing the time and then auto- matically shut off after 5 seconds.
Press the DISP while the ignition switch is in the “ OFF ” po- sition.
MUt LEVEL | 0 | ~ | 20 | ~ | 80 |
•A italicized letter is an initial value.
SacramentoCD33_Eng | 3 | 2/5/03, 4:27 PM |