Blaupunkt MP3000 manual Installations, Supplied Mounting Hardware, Precautions, Mounting Example

Installations

Supplied Mounting Hardware
ENGLISH
Sleeve	Bushing,	Locking	Mounting Strap	Release
	Screw	screw	and Screw	Keys

Precautions

•Be sure to detach the front panel before you start in- stalling the unit.

•Choose the mounting location carefully so that the unit will not interfere with the normal driving operations of the driver.

•Use only the supplied mounting hardware for a safe and secure installation.

•When mounting the unit in a car, keep the unit as level as possible. If the unit must be mounted at an angle, due to the design of the vehicle, make sure that the unit does not tilt upward by more than 30°.

•Turn-off Demo mode before use.

Mounting Example

Installation in the dashboard.

1. Install the sleeve in the dashboard.

2. Select and bend the appropriate tabs to hold the sleeve

firmly in place.

E-16

Mounting Strap Use

3. Attaching the Mounting Strap to the underside of the dash board, using screw.

Attach the back of the unit to the Mounting Strap us- ing the support stem bolt and hardware.

Bushing Use

3. As shown in the figure below, securely fasten the screw, which has been inserted into the bushing to the rear of the set.

Fire wall

The distance to the fire wall var- ies due to the type of the car. Be sure to secure the unit by prop- erly inserting the bushing.

Caution

Insufficient fastening of the screw may cause some CD’s to skip.

If your car has no accessory position on the ignition key switch (POWER SELECT switch)

The illumination on the front panel is factory-set to be turned on even when the unit is not being played. However, this set- ting may cause some car battery wear if your car has no ac- cessory position on the ignition key switch. To avoid this battery wear, set the POWER SELECT switch located on the bottom of the unit to the B position, then press the RESET button. The illumination is reset to stay off while the unit is not being played.

Reset button

Press the reset button with the point of a sharp object such as a ball-point pen.

POWER SELECT SWITCH (Located on the bottom of the unit)

Change the position with a jeweler’s screwdriver, etc.

A: Your car has an accessory position on the ignition switch.

B: Your car has no accessory position on the ignition

switch.

Be sure to press the reset button after changing the switch and connecting the lines.

Note

If set to the B position, demonstration mode will be elimi- nated.

MP3000_body_en 16 9/4/01, 4:24 PM