Blaupunkt MPA160us manual Blaupunkt Specifications MPA160US, 2/1 Channel Amplifier

BLAUPUNKT SPECIFICATIONS - MPA160US, 2/1 CHANNEL AMPLIFIER

Below is a basic trouble-shooting guide to assist in seeking out and correcting a problem that may occur in the installation process. Although lengthy, this chart cannot address every single problem possible but mainly the ones most common.

PARAMETER/FEATURE	VALUE
Channels	2/1 (3 in passive bridged mode)
Size ( W x H x D)	8.69 x 2.19 x 6.75 inches (220 x 56 x 170mm)
Weight	4.0 lbs (1.8 kg)
Crimping style speaker terminals?	YES
Maximum terminal wire size	8 ga.
Subsonic filter	YES (10 Hz)
Separate front/rear or left/right gains?	NO
Spade type auto fuses?	YES
Speaker short, short to +12V, and short to ground protection?	YES
High, low, and reverse voltage protection?	YES
Power output transistors	High current, bipolar outputs
Switching power supply transistors	High-Speed, MOSFET’s
Minimum speaker impedance	2 ohms (non-bridged mode only)
	4 ohms ONLY in bridge mode
PERFORMANCE DATA	VALUE
Rated power output @ 0.1% THD
2 channels into 4 ohms / 2 ohms	2 x 35 W / 2 x 50 W
1 channel into 4 ohms	1 x 90 W
Total Harmonic Distortion @ rated full output	0.06% THD
Rated Signal/Noise ratio (averaged value)	> 90 dBA
Measured @ full rated power	102
Measured @ 1 watt / 1 kHz	87
Damping factor	>100
Frequency response (full-range mode)	20 - 50,000 Hz
High-pass crossover frequency limits	N/A
Low-pass crossover frequency limits	100 Hz -or- 75 Hz (switchable)
Input impedance	20 kOhms
Input signal voltage control range	0.3 - 4.0 Vrms
Current draw for undistorted output @ 14.4 VDC
@ full undistorted output, non-bridged	11.5 A (2 ch x 52 W x 4 ohms)
@ full undistorted output, bridged mode	19.0 A (1 ch x 150 W x 4 ohms)
@ 33% of undistorted power (full “music” power)	7.0 A (2 ch x 17 W x 4 ohms)
@ idle	0.5 A
Minimum battery voltage to maintain rated power	12.6 Volts DC
Usable battery voltage	10 - 18 Volts DC
Trigger line voltage range	10 - 18 Volts DC
Trigger line current draw	< 15 mA draw
Turn on delay time	@ 1.5 seconds
Thermal shutoff temperature (averaged heat-sink exterior temperature)	170°F (80° C)

NOTE: DUE TO ONGOING PRODUCT IMPROVEMENTS, DESIGN AND SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT ADVANCED NOTICE TO THE CONSUMER OR RETAILER.