Switching Traffic Messages (ARI) On
and Off
This function allows you to mute all the stati- ons which do not broadcast traffic announce- ments.
For switching ARI on and off
●Press the ARI button E.
If traffic radio is on, ‘ARI’lights up on the display Gn.
If you press the ARI button when listening to a traffic message, the ARI priority is deactiva- ted for this message. The radio switches over to the operating mode which was activated before the traffic message. But ARI priority remains activated for the further traffic mes- sages.
If your radio is tuned to a station without ARI code, the acoustic alarm will be produced after approx. 4 seconds.
●Tune to another station.
When pressing the ARI button while listening to an MW or LW station, the unit automatical- ly switches to the FM traffic station tuned in last.
Acoustic Alarm
When leaving the coverage area of the tuned in traffic station, your car radio automatically sends out an acoustic alarm after approxima- tely 30 seconds.
This alarm tone can also be heard when pressing a preset button with no ARI station allocated to it.
For switching off the acoustic alarm,
●search for a new station (see chapter ‘Tuning in a Station Automatically’). The set will then start searching for the next traffic station.
Automatic Start of the Station Seek
Operation
(cassette playback)
When leaving the coverage area of the tuned in traffic station, your car radio will automati- cally start searching for a new traffic station while you are listening to your cassette.
During the seek operation, an alarm tone is sent out.
Tape Section
Inserting a Tape
If you want to listen to a tape:
●Switch on the set.
●Insert the cassette halfway into the slot with side 1 up and without applying force; the cassette will be loaded auto- matically.
The cassette side which was played last will be reproduced.
From the display G a you can see which side is currently played. (TR1 = side 1)
Removing the Tape
To stop tape play:
●Press the 
buttons = simulta- neously.
The cassette is ejected.
Fast Forwarding and Rewinding the Tape (FF/FR)
Fast Forward Operation
●Press button FF >.
On the display Ga e.g. the ‘<< >>’ symbols illuminates to indicate fast tape operation. Once fast forwarding is finis- hed, the reversed side will start to play automatically.
DEUTSCH
ENGLISH |
PORTUGUES ESPAGÑOL SVENSKA NEDERLAND ITALIANO FRANÇAIS
27
