Blaupunkt RCM 82 Acoustic Signal after the Actuati- on of a Key Beep, Choosing the Display Colour

Acoustic Signal after the Actuati- on of a Key (BEEP)

All functions which require for a keystroke longer than two seconds (e.g. memorizing a station) are confirmed by an acoustic signal (BEEP).

For switching the BEEP tone on or off,

●press the DSC button 5.

The display Ga gives you “BEEP ON” or “BEEP OFF”.

●Using the rocker switch << / >> I you can select between ‘BEEP ON’(acou- stic signal on) and ‘BEEP OFF’(acou- stic signal off).

For memorizing your adjustment,

●press the DSC button 5 once again.

Choosing the Display Colour

With this set you can match the display colour to the colour of your vehicle’s dashboard lighting. You can choose between green and orange.

For changing the display colour,

●press the DSC button 5.

The display Ga gives you “BEEP ON” or “BEEP OFF”.

●Press the rocker switch << / >> I until

‘COLOUR’lights up on the display Ga.

For changing the colour,

●press << / >> I,

and the display colour will change.

For storing this adjustment,

●press the DSC button 5 once again.

Theft Protection by Code LED

As a preventive measure, you can let a light- emitting diode (LED) K blink in the car’s interior when it is parked.

For modifying the setting,

●press the DSC button 5.

The display G a gives you “BEEP ON” or “BEEP OFF”.

●Press the rocker switch /J until

‘LED’and a number light up on the dis- play Ga.

●Via the rocker switch << / >> I, you can adjust the following:

LED 0 - Blinking is off.

LED 1 - LED only blinks if the car radio is connected via the ignition.

LED 2 - LED blinks, if the car radio is switched off (using the ON/ OFF-button, KeyCard or ignition).

Loudness

Since your in-car sound quality is influenced by the type of the installation (amplifier), the type and arrangement of the loudspeakers, and the vehicle itself, you may individually programme at which level you want the set to start boosting the basses (loudness).

For changing this loudness level,

●press the DSC button 5.

The display Ga gives you “BEEP ON” or “BEEP OFF”.

●Now press the rocker switch / J

until ‘LOUD’and a number between 1 and 6 illuminate on the display G a.

●With the rocker switch << / >> I you can match the above mentioned loud- ness level to your personal require- ments.

For memorizing this adjustment,

●press the DSC button 5 once again.

Preset Naming

When you select a station, the display G a will give you the frequency and for RDS stations also the station name later on, e.g.

91.3 BBC3. You can replace the frequen- cy indication of all preset stations without RDS code by entering an 8-digit name.

Note the following:

DEUTSCH

ENGLISH

PORTUGUES ESPAGÑOL SVENSKA NEDERLAND ITALIANO FRANÇAIS

31