![](/images/new-backgrounds/1316828/31682825x1.webp)
would like to take advantage of full RDS service, switch to “REG OFF”.
•Press the AF button for approximately 2 seconds until “REG OFF” appears.
“REG ON” or “REG OFF” will appear briefly in the display each time the radio is switched on.
Station tuning
Automatic tuning
/![](/images/new-backgrounds/1316828/31682825xi3.webp)
•Press /
; the car radio will automati- cally search for the next station.
If you hold /
pressed up or down on the rocker switch, seek tuning will speed up in the upwards or downwards direction.
Manual tuning:
•Press << >>; the frequency will change in short intervals in the downwards or upwards direction.
If you hold << >> pressed to the left or the right on the rocker switch, the frequency scan will speed up.
Selecting a waveband
With this car radio you can select between the following wavebands:
FM 87.5 - 108 MHz
MW 531 - 1602 kHz
LW 153 - 279 kHz
•Select the desired waveband by press- ing the BND button.
Note:
In the DSC menu it is possible to block MW or LW or both wavebands for station selec- tion.
The advantage of doing this is that only the required wavebands can be selected and it is no longer necessary to press BND so of- ten. If necessary, refer to the section on “DSC programming – AM ON or AM OFF”.
Seek tuning
Up
Down
<</ >> Up/down in short intervals
(for FM only, “AF” must be switched off)
Manual tuning with << >>
You can also tune into a station manually.
Requirement:
AF and PTY must be switched off (i.e. the symbols do not light up in the display).
If necessary, deactivate these functions:
•Press AF or PTY.
Scrolling through the broadcast- ing networks (FM only)
You can use the << >> buttons to tune into stations in your reception area.
If it is possible to receive several pro- grammes in the same broadcasting network, you can scroll through them in the forwards direction by pressing >>, or backwards us- ing the << button, e.g. NDR 1, 2, 3, 4, N- JOY, FFN, ANTENNE ... .
For this to work properly you must have al- ready tuned into the stations at least once and “AF” must be active (lights up in the dis- play).
To do this, you can start the Travelstore seek operation:
•Press BND for 2 seconds; the system will start to run through the frequency band.
40