Quick reference

1Switching on/off with the buttons: Press one of the buttons illustrated here after you have inserted the Key- Card.

The unit will play at the pre-adjusted volume.

Switching on/off with the KeyCard:

The set is switched on or off by insert- ing or removing the KeyCard.

Note:

Be sure to read the information in the section on “KeyCard theft protection system”.

Switching on/off via the ignition:

If the equipment has been connected correspondingly, the set can also be turned on and off with the vehicle igni- tion.

After the ignition has been switched off, a double beep tone will remind you that you should remove the KeyCard before leaving your vehicle.

Switching on when the ignition is switched off:

To keep on operating the set when the ignition is switched off (KeyCard is in- serted), proceed as follows:

Press ON after you hear the double beep tone.

The unit will turn on.

To prevent the battery from going dead, the system will turn off automati- cally after it has played for one hour.

2VOL+ / VOL- Alters the volume.

Each time the set is switched on, it will play at the pre-adjusted volume (VOL FIX).

You can also change the VOL FIX set- ting (see the section on “DSC pro- gramming”).

3

Instantly mutes the volume.

Press the button to mute the volume immediately. “MUTE” will appear in the display.

Cancel the function by pressing button or VOL+.

If you press VOL-, the normal volume will be the same as the mute volume.

To programme the mute volume level, proceed as follows:

Set the desired volume.

Press for 2 seconds until you hear a beep.

Now this volume level is stored as your mute volume.

Extra function

Press to store settings made in the DSC menu.

4SC - Scan Radio operation

Scan

Press SC briefly -

“FM SCAN” will alternate with the ab- breviated name of the scanned station in the display. The unit will scan all of the FM stations in the current recep- tion range.

Preset Scan

Preset Scan cannot be started unless PTY has been switched off (“PTY” does not light up in the display). Press SC for approximately 2 seconds until you hear a beep.

PORTUGUÊS ESPAÑOL SVENSKA NEDERLANDS ITALIANO FRANÇAIS ENGLISH DEUTSCH

31

Page 4
Image 4
Blaupunkt RD 148 operating instructions Quick reference