Blaupunkt Sydney RCM 126 Audio Features, Cassette Features, DMS CD Changer Control Fea- tures

Audio Features:

35 x 4 Watts Peak Internal Power

Dual-Level Fader

4-Channel2.0 V Preamp Out w/75 Ohm

Resistance

Switchable Auxiliary Input

Quick reference

@Switching on/off at a ON button:

Press ON.

When switching the set on with the ON button, the KeyCard has to be insert- ed. The unit will play with the pre- adjusted volume.

After the ignition has been switched off, a double beep tone will remind you that you should r&rove- . . the KevCard,

before leaving your vehicle.

Switching on with the ignition being

switched off: I

Cassette Features:

Soft-Touch, Full-Logic Deck

Super CPS Program Search

Tape Scan & Blank Skip

Dolby B Noise Reduction

AutoMetal Tape Equalization

DMS CD Changer Control Fea- tures:

Controls Blaupunkt CDC-A05 or CDC- A071 Changer

Disc Naming

Track Scan

MIX CD

MIX MAG

Other Features:

Quick-Release Wire Harness

DIN Chassis, Bracket & Hardware

Dimensions 179 x 50 x 150 mm

Designed, Engineered and Manufactured by Blaupunkt in Germany

Switching on/off with the KeyCard: ’

Turn the unit ON.

Make the orange tongue stick out by pressing it into the radio so that it pops out. Insert the KeyCard into the slot with the gold contact facing up and the arrow pointed into the unit.

Note:

Read the information in chapter “Key- Card theft protection system”.

Switching on/off via the ignition:

When connected correspondingly, the set can also be turned on and off via the vehicle ignition.

To keep on operating the set when the ignition is switched off (KeyCard is in- serted), proceed as follows:

Press ON after the double beep tone. The unit will be turned-on.

---_

@VOL+ / VOL-

To alter the volume.

Each time the set is switched on, it will play with the pre-adjusted volume (VOL FIX).

You may also change the VOL FIX set- ting (see chapter “DSC programming”).

For instantly muting the volume.

By pressing the r$j button the volume will be muted immediately. “MUTE” will appear in the display.

The function is cancelled by pressing button r#j or VOL+.

5

When pressing VOL-, the normal vol- ume will be by one grade lower than the mute volume.

To program the mute volume level, proceed as follows:

•Adjust the desired volume.

•Press r%j for two seconds until you hear a beep.

Now this volume level is stored as your mute volume.

Extra function #

Memory storing button in the DSC menu.

Press repeatedly to switch between the FM memory banks I, II and T (Travelstore).

When pressing this button, the system will automatically switch to FM.

Extra function FM1

To store the six most powerful stations automatically with Travelstore:

Press FMT until you hear a beep or “T-STORE” appears in the display.

05 AMT

AM switch

Extra function AMT

To store the six most powerful stations automatically with Travelstore:

Press AMT until you hear a beep or “T-STORE” appears in the display.

@ Rocker switch

Station search (seek tuning)

UP

Down

Up/Down in short intervals when AF is off (manual tuning)

When AF is on, press -z&> to seek previously-turned RDS sta- tions. Once RDS stations have been turned in by radio, they are added to this RDS seek table. e.g. WNEW, WNYC-FM, THE WAVE.

TaDe Operation

A I v Track selection (S-CPS) A Up v Down

>>Fast forward << Fast rewind

Stop function by pressing AV.