Blaupunkt Sydney RCM 126 appendix @ Dis, @Ld, @ Aud

@PTY (Program Type)

In the PTY mode, the preset buttons become program type buttons. With each preset you can select one pro- gram type, such as for example

NEWS, SPORT, ROCK, CLASSICL, etc.

@SRC (source)

You can switch between the different audio sources radio, tape, and CDC/ AUX (if activated).

@DIS

Radio ooeration

When an RDS station is received, press the DIS button and the frequen- cy will be displayed for approximately four seconds.

TaDe ODeratiOf7

When pressing the DIS button, the sta- tion name or frequency will be dis- played for approximately four seconds.

.*

Chanaer operation (optional)

To switch the display mode and select between name, time (playback time) and number (disc number):

• Press DIS briefly.

@RM (Radio Monitor)

Press this button to listen to the radio while fast forwarding or rewinding the tape.

To switch RM on/off: Press RM.

When this function has been activated, “RM” shows on the display panel. The radio is played back during fast tape run.

’Fress to eject the tape.

@1, 2,3, 4, 5, 6 - preset buttons

On FM, you can store six stations for each of the memory banks I, II and T. On AM, you can store six stations.

To store a station: Press a preset button during radio operation and hold down until the set resumes play after the muting and you hear a beep.

To recall a station: Select the desired waveband. On FM, also adjust the

corresponding memory bank. Then press the relevant preset button briefly.

Extra function for preset buttons

To store and recall a PTY program

type.

On FM, vou can store and recall one program-type on/from each preset but- ton when PTY is active (“PTY” lights up in the display).

@Cassette loading slot

Insert the tape with side A or 1 facing up, the open side showing to the right.

@AV Tape side selector

Press this button to switch over to the other side during tape operation. The display shows “TR 1” or “TR 2”.

@B

Dolby B NR*

Press this button to play back a tape which has been recorded with Dolby-B noise reduction. When this button is pressed, “B“ lights up in the display.

*Noise Reduction system manufactured under li- cense from Dolby Laboratories Licensing Cor- poration, “Dolby“ and the double-D symbol are trademarks of Dolby Laboratories Licensing COP poration.

9

@LD

@ GE0 @ AUD

Loudness - When listening at a low level, the Loudness function creates a more natural sound by boosting the low frequency range.

LD on/off: Press the button.

When the Loudness function is active, “LD”will light up in the display.

See chapter “DSCprogramming” for more information.

To adjust the balance (left/right) and fader (front/rear) with the rocker switch.

To adjust the treble and bass frequen- ties with the rocker switch.

ATreble +

@DSC (Direct Software Control) Use the DSC function to customise certain programmable, basic settings

to suit your personal needs and prefer- ences. See chapter “DSCprogram- ,ming” for more information.

A Fader front

VFader rear << Balance left >> Balance right

The last setting will be stored automat- ically.

To switch off GEO: Press button once again.

If the setting remains unchanged within four seconds, the display will switch back to the previous condition._

VTreble -

xc B a s s - >> B a s s +

The last setting will be stored automat- ically.

To switch off AUD: Press button once again.

If the setting remains unchanged with- in four seconds, the AUD setting will be terminated automatically.

10