Installation
Oven Assembly
CONVEYOR
1.Slide the conveyor assembly through the left hand tunnel opening until the sprocket is in- side the control box. See Figure 6.
2.Install the drive belt on the motor and then around the pulley on the conveyor assembly. See Figure 7. Pull the conveyor assembly back to tighten the belt.
Unless specified otherwise, conveyor travel is factory set for left to right operation when facing the front of the oven. To reverse the direction of the drive motor (if necessary), exchange A1 and A2.
WARNING!!
Disconnect the power supply before reversing the drive motor.
CRUMB PANS
1.Install the crumb pans on both ends of the conveyor.
Figure 6
Figure 8
Figure 7
8