EN
37
Refer to the nearest Authorised Service
Agent for installation of the product. To
make the product ready for use, review
the information in the user manual and
make sure that the electricity, tap water
supply and water drainage systems are
appropriate before calling the Authorized
Service Agent. If they are not, call a
qualified technician and plumber to have
any necessary arrangements carried
out.
C Preparation of the location and
electrical, tap water and waste
water installations at the place of
installation is under customer's
responsibility.
B Installation and electrical
connections of the product must
be carried out by the Authorized
Service Agent. Manufacturer shall
not be held liable for damages that
may arise from procedures carried
out by unauthorized persons.
A Prior to installation, visually check
if the product has any defects on
it. If so, do not have it installed.
Damaged products cause risks for
your safety.
C Make sure that the water inlet
and discharge hoses as well as
the power cable are not folded,
pinched or crushed while pushing
the product into its place after
installation or cleaning procedures.
Appropriate installation
location
• Place the machine on a rigid floor.
Do not place it on a long pile rug or
similar surfaces.
• Total weight of the washing machine
and the dryer -with full load- when
they are placed on top of each other
reaches to approx. 180 kilograms.
Place the product on a solid and flat
floor that has sufficient load carrying
capacity!
• Do not place the product on the
power cable.
• Do not install the product at places
where temperature may fall below
0ºC.
• Place the product at least 1 cm
away from the edges of other
furniture.
Removing packaging
reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove
the packaging reinforcement by pulling
the ribbon.
Removing the
transportation locks
A Do not remove the transportation
locks before taking out the