EN
38
packaging reinforcement.
A Remove the transportation safety
bolts before operating the washing
machine, otherwise, the product will
be damaged.
1. Loosen all the bolts with a spanner
until they rotate freely (C).
2. Remove transportation safety bolts
by turning them gently.
3. Attach the plastic covers supplied in
the User Manual bag into the holes
on the rear panel. (P)
C Keep the transportation safety
bolts in a safe place to reuse when
the washing machine needs to be
moved again in the future.
C Never move the product without the
transportation safety bolts properly
fixed in place!
Connecting water supply
C The water supply pressure required
to run the product is between 1
to 10 bars (0.1 – 10 MPa). It is
necessary to have 10 – 80 liters of
water flowing from the fully open tap
in one minute to have your machine
run smoothly. Attach a pressure
reducing valve if water pressure is
higher.
C If you are going to use the double
water-inlet product as a single (cold)
water-inlet unit, you must install the
supplied stopper to the hot water
valve before operating the product.
(Applies for the products supplied
with a blind stopper group.)
C If you want to use both water
inlets of the product, connect the
hot water hose after removing the
stopper and gasket group from
the hot water valve. (Applies for
the products supplied with a blind
stopper group.)
A Models with a single water inlet
should not be connected to the
hot water tap. In such a case the
laundry will get damaged or the
product will switch to protection
mode and will not operate.
A Do not use old or used water inlet
hoses on the new product. It may
cause stains on your laundry.
1. Connect the special hoses supplied
with the product to the water inlets
on the product. Red hose (left) (max.
90 ºC) is for hot water inlet, blue
hose (right) (max. 25 ºC) is for cold
water inlet.