5-3. Changing Feeder Drive Roll And Wire Inlet Guide
2
6
1
7
8
4
3
5
Tools Needed:
5/16 in
Turn Off wire feeder and welding power source. Lay wire conduit out straight.
Open gun pressure roll assembly, and cut welding wire off at contact tip.
1Pressure Roll Assembly
2Wire Spool
For welding power sources without contactor, retract wire onto spool.
For welding power sources with a contactor, energize power source, turn On feeder, press Brake Re- lease button, and retract wire onto spool.
3Shaft
4Setscrew
5Drive Roll
Use wire brush to clean drive roll. Install drive roll with desired groove in, and turn drive roll so one setscrew faces flat side of shaft.
6Bearing
7Wire Conduit Fitting
Line up drive roll groove with bear- ing groove and opening in conduit fitting. Tighten setscrews.
8 Wire Inlet Guide
Pull guide toward rear of feeder to remove. Install new guide.
Thread welding wire and adjust drive roll pressure, if necessary (see Section
Close gun pressure roll assembly, and reinstall gun cover.
151 778 / Ref. 151
