Hobart OM-1581 manual 12 VAC/Contactor Control Plug Information

3-12. 115 VAC/Contactor Control Plug Information

J	A
I	K
	B
H	N L C

GM D

F E

2

1 Interconnecting Cord

2 115 VAC/Contactor Control

Plug PLG5

If CC or CC/CV welding power source is equipped with matching 14-socket receptacle, insert plug, and tighten threaded collar. Proceed to Section 3-14.

If plug PLG5 will not connect to CC welding power source receptacle, use the following pin information and Section 3-13 to replace PLG5 with a suitable plug.

1

	Pin*	Pin Information
	A, B	Contact closure to A completes contactor control circuit.
Remote	I	115 volts ac.
Contactor	J	Contact closure to I completes 115 volts ac contactor control circuit.
	G	Circuit common for 115 volts ac circuit.
	C	+10 volts dc output to remote control.
Remote	D	Remote control circuit common.
Voltage Control	E	0 to +10 volts dc input command signal from remote control.
	K	Chassis common.

*The remaining pins are not used.

Ref. S-0004-A / Ref. 151 772

OM-1581 Page 18