Bloomfield 0420 Troubleshooting Suggestions, Symptom, Possible Cause, Suggested Remedy

	TROUBLESHOOTING SUGGESTIONS
SYMPTOM	POSSIBLE CAUSE	SUGGESTED REMEDY
Water won’t heat	Brewer unplugged or circuit	Check power supply cord
	breaker tripped	Check / reset circuit breaker
	Temperature setpoint too low	Set for desired temperature
	Hi-Limit safety switch tripped	Allow to cool hi-limit will self-
		reset
	Damaged internal component	Examine wiring & connectors,
	or wiring	controller, water level probe and
		heating element
		Repair/replace as needed
Coffee level too high or low	Volume keys not programmed	Program volume keys
Brew chamber overflows	Too many filter papers or wrong	Use one (1) genuine Bloomfield
	filter paper	filter per brew
	Brew chamber dispense hole	Thoroughly clean brew
	plugged	chamber
	Too much coffee or too fine a	Use correct grind and amount
	grind	of coffee
	Not using pulse brew feature	Program vol. key for pulse brew
Sprays water from brew head	Spray gasket improperly	Check/reinstall gasket on
	installed	INSIDE of brew head
	Spray disk plugged	Clean spray disk
No brew (faucet flows OK)	Damaged internal component	Check keypad, controller, and
	or wiring	pump
		Repair, replace as needed
No brew plus no flow from hot	Water supply OFF	Turn water supply ON
water faucet
	Solenoid inlet strainer plugged	Clean strainer
	Water filter (if used) plugged	Replace filter element
	Damaged internal component	Check controller and water level
	or wiring	probe
No flow from hot water faucet	Damaged internal component	Check solenoid and switch
(brew OK)	or wiring	Repair/replace as needed
Poor coffee quality	Keep brewer and airpots clean.
	Install optional taste and odor filter, and replace cartridges
	regularly.
	Use a quality coffee with a consistent roast. Use proper grind
	and amount of coffee per brew.

11