®

Contact 1-800-762-1142 for assistance.

 

Do not return to place of purchase.

 

 

 

 

Step 6 – Attach Engine/Post to Platform

Insert end of Post without holes over Gas Line, being careful not to bend

Gas Line.

Slide Post into collar of Platform so Post rests completely on Platform.

Tighten bottom three setscrews with hex (Allen) wrench supplied.

Make sure Post is perpendicular to Base.

Use top three setscrews to adjust Post’s angle as necessary.

Tighten all six setscrews.

Note: Post must be perpendicular to Base. Failure to do so will adversely affect burner performance.

Step 7 – Connect Gas Line to Engine

Attach Gas Line to Control Valve:

Pull collar of Gas Line back.

Insert Gas Line over Control Valve.

Release collar and it should lock in place. (Tip – push Gas Line up from bottom of Post to make a good seating before releasing the collar.)

Gently tug on line to test for proper connection. If Gas Line moves it is not properly connected. Do not proceed until you have a proper connection.

Fully tighten the (4) screws from Step 5.

9

Owner’s manual: model 200209 outdoor patio heater

7/28/04