Contact | ® |
Do not return to place of purchase. |
|
|
|
|
|
Step 4 – Insert Gas Line through Platform/Attach Shroud Cover
Insert Gas Line up through large hole in Platform from underneath between center and left leg as shown in illustration.
Slide Shroud Cover over Gas Line, then over Platform/Leg assembly until bottom of Shroud rests on Base.
Step 5 – Attach Engine to Post
Lay Engine Assembly on its side, using carton for support.
Remove and save Control Knob.
Remove and save Engine Access Panel by removing (1) black
Thumbscrew from bottom of Access Door.
Disconnect wire from Igniter by gently pulling wire from back of box.
Align (4) holes in top of Post with (4) holes in bottom of Engine.
Note: One hole is at a different level than the rest. Make sure that all 4 holes line up properly.
Insert (4) Small Screws enough to hold Engine in place. They will be fully tightened at the end of Step 7.
Note: Do not replace Engine Access Panel until Step 13.
Owner’s manual: model 200209 outdoor patio heater | 7/28/04 | 8 |