Advanced Functions
Driver to Passenger or Bike to Bike INTERCOM
The BLUEANT INTERPHONE has motorcycle intercom system that allows driver to passenger conversations. This intercom features
Intercom Pairing Procedure:
1. Prepare two BLUEANT INTERPHONES.
Note: Make sure to switch off the phones paired to these two headsets.
2.Set the two units to pairing mode (from off, press and hold the MFB(1) of the BLUEANT INTERPHONE for about 5 seconds or until you hear the 2nd beep).
3.When the two are set to pairing, press Volume Up(3) button of BLUEANT INTERPHONE N°1 for about 5 seconds (1st beep followed by 5 successive beeps will be heard and then BLUEANT INTERPHONE N°1 turns off).
4.Wait for 3 seconds and then switch on BLUEANT INTERPHONE N°1.
5.Press Volume Down(4) button of BLUEANT INTERPHONE N°2 for about 5 seconds (1st beep followed by 5 successive beeps will be heard). BLUEANT INTERPHONE N°2 pairing blink will change to blinking blue while BLUEANT INTERPHONE N°1 will again turn off.
6.Wait for 3 seconds and then switch on again BLUEANT INTERPHONE N°1.
7.Press MFB(1) of BLUEANT INTERPHONE N°1 for about 3 seconds (2nd beep) to connect to BLUEANT INTERPHONE N°2.
The
Note: This has to be done only once every time you want to use 2 different BLUEANT INTERPHONE together.
Using as an Intercom:
To switch from phone to intercom, press MFB(1) for 3 seconds or until you hear the 2nd beep.
To switch from intercom to phone, press MFB(1) for 1 second or until you hear the 1st beep.
Important Notes:
1.Both BLUEANT INTERPHONES’ must be in intercom mode to allow intercom.
2.When the BlueAnt Interphones go out of range of each other they will drop out of intercom mode and will need to be manually reconnected when back in range. This is done by simply pressing and holding the MFB
11
