Using the Headset Clip Mount with Adhesive
1.Before removing the protective strip from the
2.Clean the part of the helmet that the Headset Clip Mount with Adhesive will be attached to. Remove any dirt or grease. Do not use cleaners that may damage the helmet or that will leave an oily residue. Make sure the surface is dry before continuing.
3.Check again the positioning of the clip. Once it is mounted it will not be possible to move without making the
adhesive unusable. So please take care when choosing its position.
4.Note that the small section of the two holes/slots in the Clip must be faced towards the bottom of the helmet. As shown in the picture to the right.
5.Remove the protective strip from the
Mounting the InterPhone
1.Take your InterPhone Headset and slide it down into the slots in the Headset Clip Mount. Make sure that it’s perfectly fitted and locked into place by trying to extract it, pulling upwards.
2.Now you need to attach the speaker and microphone arm to the inside of the helmet. Take the Velcro pad which the speaker will attach to, and test for the best position to fix it. The Velcro Pad should be fixed
at the height of your ear in the helmets ear pocket. You will need to put the helmet on a few times to find the optimum position to apply the pad. When the correct positioning is found, remove the protective strip and apply the Velcro
Pad.
5
