Graco, Raise Seat Back Position Handle | BOB AA000001 specification

Graco®

See the “Reclining Seat” section of your stroller owner’s manual.

Move car seat handle into upright carrying position.

Using a Phillips screwdriver, remove both screws.

TIP: Attach short screws to accessory bar for future use.

CAUTION: Ends of accessory bar are sharp!

POSITION CAR SEAT

Place car seat “rear facing” onto ICSA main bar, in a straight downward motion.

Slide grooves on underside of car seat onto ICSA main bar.

Red hook on Graco® should be under main bar.

FASTEN RESTRAINT BELT

Fasten restraint belt over top of infant car seat as shown.

OMA09D

Image 7

Contents

Infant Car Seat Adapter Instructions Accessory Bar Attach Main BAR Attach Restraint Belt M Attach Restraint Belt M/F and Arms Position Restraint Belt F Prepare Stroller for Infant CAR Seat InstallationAttach Restraint Belt F Buckle Belt Position ARM Engage CAR Seat Fasten Restraint Belt Install Infant CAR SeatBritax Lower Seat Back Raise Handle Tighten Restraint Belt Peg PéregoRaise Seat Back Position Handle Position CAR Seat Engage CAR Seat Graco Remove Accessory BARRaise Seat Back Position Handle Graco To Remove CAR SeatSET Parking Brake Remove CAR Seat Britax Peg Pérego Rotate Tray Tray InstallationRemove Screws Remove Accessory BAR Engage Tray Replace Sharp Screw Remove Restraint Belt MRemove Restraint Belt F Remove Sharp Screw and Belt Infant Car Seat Adapter Warnings Warranty claims must be made through an authorized dealer Limited Warranty