Bosch Appliances D720, D720B, D720W Reset Sensors, COMMAND 4 7

Reset Sensors

I have this feature.

I do not have this feature.

This feature requires a passcode.

Command 47 resets faulted detection devices. Devices can include smoke

detectors, shock sensors or a variety of other detection devices. Ask your alarm

technician which points you can reset from the keypad by entering Command

47.

COMMAND 4 7

To reset detectors:

1. Ensure your security system is disarmed.

2. Press the [COMMAND] bar. The Command mode indicator light

comes on.

3. Press the [4] key, and then press the [7] key. The display flickers

momentarily and the keypad emits multiple pips during reset.

If you enter this function and the detector or sensor resets momentarily but then

returns to a faulted condition, the conditions causing the activation can still be

present or the detector is faulty. Check to be certain there is no smoke, fire, or

other danger present.

If you cannot reset the detector or sensor, contact your security company.

Contents

Main Table of Contents Fire Safety Possible escape routes through open windows marked with arrows. In Case of Fire Introduction Maintenance and Service AC Power Failure The D720 Series Keypad Security System Basics What is a Point? Controlled Points 24-Hour Points Keypad Features The Keypad COMMAND Bar Enter (ENT) Key Function Keys Turning the System On (Arming) Turning the System Off (Disarming) Silencing an Alarm To Silence an alarm: Reporting to the Central Station Keypad Tones Turn the Entire System On With Delays COMMAND 1 Arming with COMMAND 1: Turn the Entire System On Without Delays COMMAND 1 1 Using Command 11: Turn On the Perimeter With No Delays COMMAND 2 Arming with COMMAND 2: Turn On the Perimeter With Delays COMMAND 3 Arming with Command 3: Page Send Report COMMAND 4 1 & 4 2 To use COMMAND 4 1 or COMMAND 4 2: Enable Remote Account Management COMMAND 4 3 To use COMMAND 4 3: Walk Test COMMAND 4 4 To use Walk Test: Reset Sensors COMMAND 4 7 To reset detectors: Delete Passcodes COMMAND 5 3 To delete passcodes: Personal Passcode Change COMMAND 5 5 To change your personal passcode: Fire Test COMMAND 5 8 To use Fire Test: Watch Mode COMMAND 6 To use COMMAND 6: Special Alert COMMAND 7 To engage COMMAND 7: Partially Turn On the Perimeter COMMAND 8 To arm with COMMAND 8: Special Alert COMMAND 9 To engage COMMAND 9: Bypass a Point COMMAND 0 To use Bypass a Point: Unbypass a Point COMMAND 0 0 To Unbypass a Point: Turning the System On With a Duress Passcode Passcode + 1, or + 2 Force Arming the System To arm with points faulted: Security System Glossary Security System Limitations