Bosch Appliances D720, D720B, D720W Unbypass a Point, COMMAND 0 0

Unbypass a Point

I have this feature.

I do not have this feature.

This feature requires a passcode.

Unbypassing a point is a way to return a bypassed point to the security system so

it can respond to trouble and alarm conditions.

COMMAND 0 0

To Unbypass a Point:

1. Ensure your security system is disarmed.

2. Press the [COMMAND] bar. The Command mode indicator light

comes on.

3. Press the [0] key, then press the [0] key again. The system is now the

Unbypass mode.

4. To unbypass a point, press the number key that corresponds to the

number of the point that is flashing slowly, and then press the [ENT]

key. The point status light stops flashing, indicating the point is

unbypassed.

Contents

Main Table of Contents Fire Safety Possible escape routes through open windows marked with arrows. In Case of Fire Introduction Maintenance and Service AC Power Failure The D720 Series Keypad Security System Basics What is a Point? Controlled Points 24-Hour Points Keypad Features The Keypad COMMAND Bar Enter (ENT) Key Function Keys Turning the System On (Arming) Turning the System Off (Disarming) Silencing an Alarm To Silence an alarm: Reporting to the Central Station Keypad Tones Turn the Entire System On With Delays COMMAND 1 Arming with COMMAND 1: Turn the Entire System On Without Delays COMMAND 1 1 Using Command 11: Turn On the Perimeter With No Delays COMMAND 2 Arming with COMMAND 2: Turn On the Perimeter With Delays COMMAND 3 Arming with Command 3: Page Send Report COMMAND 4 1 & 4 2 To use COMMAND 4 1 or COMMAND 4 2: Enable Remote Account Management COMMAND 4 3 To use COMMAND 4 3: Walk Test COMMAND 4 4 To use Walk Test: Reset Sensors COMMAND 4 7 To reset detectors: Delete Passcodes COMMAND 5 3 To delete passcodes: Personal Passcode Change COMMAND 5 5 To change your personal passcode: Fire Test COMMAND 5 8 To use Fire Test: Watch Mode COMMAND 6 To use COMMAND 6: Special Alert COMMAND 7 To engage COMMAND 7: Partially Turn On the Perimeter COMMAND 8 To arm with COMMAND 8: Special Alert COMMAND 9 To engage COMMAND 9: Bypass a Point COMMAND 0 To use Bypass a Point: Unbypass a Point COMMAND 0 0 To Unbypass a Point: Turning the System On With a Duress Passcode Passcode + 1, or + 2 Force Arming the System To arm with points faulted: Security System Glossary Security System Limitations