Bosch Appliances D720, D720B, D720W Special Alert, COMMAND 7

Special Alert

I have this feature.

I do not have this feature.

This feature requires a passcode.

This command is a manually operated and initiated alarm command.

Command 7 is programmed to respond to numerous situations that can need

immediate attention. This command can also send a silent alarm to your security

company without sounding an alarm signal on the premises. Check with your

security company for the options they offer.

COMMAND 7

To engage COMMAND 7:

1. Press the [COMMAND] bar. The Command mode indicator light

comes on.

2. Press the [7] key. Your COMMAND 7 special alert is programmed to:

_____ notify your alarm company.

_____ ring a bell on your premises.

Description:

__________________________________________________________

Contents

Main Table of Contents Fire Safety Possible escape routes through open windows marked with arrows. In Case of Fire Introduction Maintenance and Service AC Power Failure The D720 Series Keypad Security System Basics What is a Point? Controlled Points 24-Hour Points Keypad Features The Keypad COMMAND Bar Enter (ENT) Key Function Keys Turning the System On (Arming) Turning the System Off (Disarming) Silencing an Alarm To Silence an alarm: Reporting to the Central Station Keypad Tones Turn the Entire System On With Delays COMMAND 1 Arming with COMMAND 1: Turn the Entire System On Without Delays COMMAND 1 1 Using Command 11: Turn On the Perimeter With No Delays COMMAND 2 Arming with COMMAND 2: Turn On the Perimeter With Delays COMMAND 3 Arming with Command 3: Page Send Report COMMAND 4 1 & 4 2 To use COMMAND 4 1 or COMMAND 4 2: Enable Remote Account Management COMMAND 4 3 To use COMMAND 4 3: Walk Test COMMAND 4 4 To use Walk Test: Reset Sensors COMMAND 4 7 To reset detectors: Delete Passcodes COMMAND 5 3 To delete passcodes: Personal Passcode Change COMMAND 5 5 To change your personal passcode: Fire Test COMMAND 5 8 To use Fire Test: Watch Mode COMMAND 6 To use COMMAND 6: Special Alert COMMAND 7 To engage COMMAND 7: Partially Turn On the Perimeter COMMAND 8 To arm with COMMAND 8: Special Alert COMMAND 9 To engage COMMAND 9: Bypass a Point COMMAND 0 To use Bypass a Point: Unbypass a Point COMMAND 0 0 To Unbypass a Point: Turning the System On With a Duress Passcode Passcode + 1, or + 2 Force Arming the System To arm with points faulted: Security System Glossary Security System Limitations