Bosch Appliances D720, D720B, D720W Delete Passcodes, COMMAND 5 3

Delete Passcodes

I have this feature.

I do not have this feature.

This feature requires a passcode.

Use Command 53 to delete a personal passcode from your system without

assistance from your security company. You need to know the user number for the

passcode you want to delete. The two-digit user numbers identify users in reports

transmitted from your system.

COMMAND 5 3

To delete passcodes:

1. Ensure your security system is idle.

2. Press the [COMMAND] bar. The Command mode indicator light

comes on.

3. Press the [5] key, and then press the [3] key. Your security system is

now in the Passcode Delete Mode.

4. Enter the two-digit user number for the passcode you wish to

delete. Press [ENT]. The passcode is now deleted.

Contents

Main Table of Contents Fire Safety Possible escape routes through open windows marked with arrows. In Case of Fire Introduction Maintenance and Service AC Power Failure The D720 Series Keypad Security System Basics What is a Point? Controlled Points 24-Hour Points Keypad Features The Keypad COMMAND Bar Enter (ENT) Key Function Keys Turning the System On (Arming) Turning the System Off (Disarming) Silencing an Alarm To Silence an alarm: Reporting to the Central Station Keypad Tones Turn the Entire System On With Delays COMMAND 1 Arming with COMMAND 1: Turn the Entire System On Without Delays COMMAND 1 1 Using Command 11: Turn On the Perimeter With No Delays COMMAND 2 Arming with COMMAND 2: Turn On the Perimeter With Delays COMMAND 3 Arming with Command 3: Page Send Report COMMAND 4 1 & 4 2 To use COMMAND 4 1 or COMMAND 4 2: Enable Remote Account Management COMMAND 4 3 To use COMMAND 4 3: Walk Test COMMAND 4 4 To use Walk Test: Reset Sensors COMMAND 4 7 To reset detectors: Delete Passcodes COMMAND 5 3 To delete passcodes: Personal Passcode Change COMMAND 5 5 To change your personal passcode: Fire Test COMMAND 5 8 To use Fire Test: Watch Mode COMMAND 6 To use COMMAND 6: Special Alert COMMAND 7 To engage COMMAND 7: Partially Turn On the Perimeter COMMAND 8 To arm with COMMAND 8: Special Alert COMMAND 9 To engage COMMAND 9: Bypass a Point COMMAND 0 To use Bypass a Point: Unbypass a Point COMMAND 0 0 To Unbypass a Point: Turning the System On With a Duress Passcode Passcode + 1, or + 2 Force Arming the System To arm with points faulted: Security System Glossary Security System Limitations