Disk Full Notification
This message will appear on the primary monitor to indicate that the unit has stopped recording because the disk is full.
In No Overwrite mode, the unit will not record over previously recorded data. To continue recording, the user must acknowledge the disk full message by pressing ENTER, then ERASE (or DELETE).
MESSAGE
DISK FULL. RECORDING HAS STOPPED.
[OK]
In Overwrite Once mode: The user must acknowledge the
The unit will resume recording when the user presses RECORD.
6.3Playback
1
2
12:34:45A PLAY
12/17/000.2p
3
4
1.Time the Data was Recorded
2.Date the Data was Recorded (If the letter A precedes the record rate, the unit is configured to record or play back audio).
3.Play Forward Mode Indicated
4.Normal Record Speed in Pictures per Second
Figure 6B - LCD during Playback
Play Forward
To begin normal playback in the forward direction, press Play Forward.
Playback is indicated via the following:
•PLAY appears briefly in the upper
•PLAY> appears on the LCD.
Reverse Play
To begin reverse playback, press Play Reverse. Reverse playback is indicated via the following:
•REVERSE PLAY appears briefly in the upper
•PLAY< appears on the LCD.
If there is only one recording session on the hard disk, the unit will indicate START OF DATA on the primary monitor.
Playback Speed
The unit plays back the data at the rate at which it was recorded. The user can alter the playback speed using Up/Down Record Speed.
Altering the playback speed overrides the speed of any incoming alarms. To clear the override, press STOP, then PLAY to resume playback at the speed that the data was recorded.
NOTE: For clear audio, playback should be at the same speed at which it was recorded.
Fast Forward
During playback, pressing Fast Forward allows viewing of data at a faster than normal rate.
Fast Forward is indicated via the following:
•FAST FORWARD appears briefly in the upper
•FFWD appears on the LCD.
PLAY FWD
Play Forward
Button
PLAY REV
Play Reverse
Button
REC SPD
Record Speed
Buttons
Fast Forward
Button
25
