AutoDome Easy | Installing the AutoDome Easy 13 |
|
|
Fig. 8.3 Installing the Dome
8.Turn the dome camera to the right approximately 15 degrees.
9.Secure the safety locking screw.
8.1.4Powering On
When AutoDome Easy’s power is turned on, there is a five (5) second pause before the dome starts its homing phase. During the homing phase, the camera pans left and right and tilts up and down. It also adjusts the lens focus. The entire homing phase lasts approximately 40 sec- onds and displays the following splash screen throughout its homing phase START UP BOSCH Version 2.0.x.
i | NOTICE! The error message: PROTOCOL IS NOT MATCHED is displayed during the | |
cycle if switches 9 and 0 are not set correctly. | ||
|
8.1.5Installing the Base to a Junction Box
i
If it is not possible to drill a hole in the ceiling for wiring, it is recommended to use a junction box (not supplied). To mount a junction box, follow all standard procedures.
NOTICE! This mounting method does not require use of the supplied mounting plate.
To install the AutoDome Easy to a junction box, follow the steps below:
1.Carefully loosen the bubble by using the torx wrench provided to remove the four (4)
2.Remove the appropriate two (2) (see Figure 8.4) black rubber plugs from the camera base.
Fig. 8.4 Removing the Plugs from the Camera Base
Bosch Security Systems, Inc. | Installation and Configuration Manual | December 06, 2006 F01U032279 |