Bosch Appliances HES3063U manual Removing the Oven Door, To replace the oven door

Removing the Oven Door

CAUTION:

When removing the door:

• Make sure oven is cool and power to the

oven has been turned off before

removing the door. Failure to do so could

result in burns.

• The oven door is heavy and fragile. Use

both hands to remove the oven door. The

door front is glass. Handle carefully to

avoid breaking.

• For safe, temporary storage, lay the door

flat with the inside of the door facing

down.

• Grasp only the sides of the oven door. Do

not grasp the handle as it may swing in

your hand and cause damage or injury.

• Failure to grasp the oven door firmly and

properly could result in personal injury or

product damage.

• Do not lay removed door on sharp or

4.	Firmly grasp both
About	sides of oven door
10°	along the door sides
Oven	(Do not use the oven
	door handle - see
Door	figure).
5. Close the door to the
Door	broil stop position (the
	oven door will stop
Hinge
	into this position just
	before fully closing).
6. With the oven door in
	the broil stop position,
	lift the oven door hinge
	arms over the roller
	pins located on each
	side of the oven frame
	(see figure).

To replace the oven door:

pointed objects as this could break the

glass. Lay on a flat, smooth surface,

positioned so that the door cannot fall

over.

To remove the oven door:

1. Be sure to read the above CAUTION before attempting to

Oven Door

About 10°

Door

Hinge

1.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - see figure).

remove the door.

2. Open oven door completely (horizontal with floor - see figure)

3. Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (see figure). A tool such as a small flat-blade screwdriver may be required.

2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (see figure). The hook of the hinge arms must be fully seated onto the roller pins.

English 25