5.Operation
5.1Connection to the vehicle
The KTS 200 is designed for operation on a vehicle with a battery voltage of 12 Volts and 24 Volts.
Make sure that the OBD diagnostic lead is correctly plugged into the KTS 200 and securely screwed in. If incorrectly plugged in, the pins on the male connector may bend or be broken off. Only use the OBD diagnostic lead supplied.
1
91
10 2
11 3
12 4
135
146
15 7
16 8
2
3
4
| BOS |
|
|
|
|
|
|
| CH |
|
|
|
|
|
|
KTS 200 | Power |
|
|
|
|
|
|
| ed by ES |
|
|
|
|
|
|
| I[tronic] |
|
|
|
|
|
|
USB |
|
|
|
|
| / 3 | Ko |
15VDC |
|
| 0 | 4 |
| ||
|
| 598 |
|
| |||
|
|
|
|
|
| ||
|
| 4 |
|
|
|
| |
|
|
|
|
|
|
|
5
7
6
Fig. 3: KTS 200 connection schematic
1OBD diagnostic socket in vehicle
2 OBD diagnostic lead
3 UNI connecting lead (special accessory)
4 KTS 200
5 Power pack
6 Connecting lead for cigarette lighter socket
7 USB connecting lead
When placing the KTS 200 on the steering wheel, there is a risk of injury due to triggering of the airbag.
Operation KTS 200 23 en
The connection to the diagnostic interface in the vehicle is made via
Rthe OBD diagnostic lead (Fig. 3, item 2) or
Rthe OBD diagnostic lead and also the UNI connecting lead (Fig. 3, item 3; special accessory) or
Rthe OBD diagnostic lead and a
Ra
5.2Turning on
The KTS 200 is normally supplied with power by the OBD diagnostic socket in the vehicle. If the position of the OBD diagnostic socket in the vehicle is not known, we recommend connecting the KTS 200 to the cigarette lighter socket using the connecting lead and searching for the OBD diagnostic socket using the KTS 200 control unit diagnosis software.
On some vehicles, the cigarette lighter socket only supplies power when the ignition is turned on.
In test steps that require the engine to be started, the battery voltage may drop to a point at which the supply from the vehicle is no longer guaranteed. In these cases, it may be necessary to use the power pack to supply the KTS 200 with power.
On some vehicles, the power supply may only be present on the OBD interface when the ignition has been turned on.
If the KTS 200 is connected to a PC/laptop using the USB connecting lead, the KTS 200 power supply must come from the power pack supplied.
5.3Turning off
The KTS 200 is always turned off when the OBD diagnostic lead, the power pack or the connecting lead for the cigarette lighter socket are not connected.
5.4Program description
The online help for the KTS 200 control unit diagnosis soft- ware is opened under “Menu >> Help” in the soft key bar. Basic information about the KTS 200 and ESI[tronic] Startcenter can be found under “ESI[tronic] trainer” in the ESI[tronic] Startcenter software.
Bosch Diagnostics | 1 689 989 001 |
