3.7Wall bracket
The KTS 200 can be hooked onto the wall bracket (special accessory in some cases) for storage.
¶Attach the wall bracket at the desired location using the 2 screw anchors and 2 wood screws supplied.
|
| BO | SCH |
|
|
|
|
| |
|
|
|
| 4 |
|
|
|
| 4 |
|
|
|
| 0 |
|
|
| [tronic] | 8 |
|
|
| 9 | |
|
| eredby ESI | ||
| KTS | 200 Pow |
| 5 |
33 mm |
|
| 4 | |
Product description KTS 200 19 en
4.Initial startup
4.1Connection
Before starting up for the first time, make sure that the mains voltage matches the voltage specified on the power pack (use power supply lead supplied).
The German power supply lead is included with the unit.
4.2Licensing with ESI[tronic] Startcenter
Before you can use the KTS 200 to perform control unit diagnosis, you must install the “ESI[tronic] Startcenter” software on a PC/laptop and then license the KTS 200.
Do not connect the KTS 200 to the PC/laptop until prompted to do so during the installation routine.
4.2.1Installing ESI[tronic] Startcenter from DVD Procedure:
1.Insert the “ESI[tronic] Startcenter” DVD in the DVD drive (e.g. “D:\”) on the PC/laptop.
2.Open the “Run” input window (select “Start >> Run...” in the taskbar).
3.Enter D:\setup.exe and confirm by clicking <OK>.
?The Setup routine is started.
Fig. 2: Wall bracket assembly
4. Select the installation language and confirm with <OK>.
The installation language selected will also be the language used in ESI[tronic] Startcenter.
5. Follow the installation instructions on the screen.
In the “Country selection” installation menu, you must select the country in which the KTS 200 will be operated.
Bosch Diagnostics | 1 689 989 001 |
