5.Operate unit with rotary switch. Once the attachment is in place, the speed of its moving components can be controlled through the use of the rotary switch at the side of the ergonomic multifunction arm. See figure 2a. The rotary switch has six positions:
a.“P,” a park position used to “park” the drive unit prior to changing the positions of the ergonomic multi- function arm.
b.“O/Off,” the off position.
c.Four speeds labeled 1, 2, 3 and 4. Speed 1 is the lowest speed. The speed increases with each
succeeding step up to the highest speed, speed 4.
All models of the Bosch Compact Series Kitchen Machines incorporate an electronic safety control to protect the motor. If the safety becomes activated, the motor will stop running. Turn the machine to off and allow to cool. See TROUBLESHOOTING at the back of this manual.
WARNING
Operate the appliance with the attachments in their operating positions, as shown in table 1, only. Do not operate at no load.
6.Turn power unit off.
When your work with the attachment is completed or the capacity of the batch feed attachment has been reached, turn the power unit to off position, “O/Off,” turn the rotary knob to the “P,” park position, to place the drives to their parked positions, and then unplug.
7.Remove the attachment. Remove the attachment from the power unit, in some cases it will be
necessary to move the arm to allow removal of the attachment. Refer to the instructions for the specific attachment being used.
8.Continue use.
If the attachment was of the batch feed type and you wish to continue using the attachment, empty the bowl or jar of the attachment per its specific instructions and reinstall the attachment as before. Repeat the steps 5 through 7 as often as necessary to complete necessary work.
9.Work completed, remove attachment.
If the attachment is of the continuous feed type, or is the batch type, and you have completed the work you wished to perform with the attachment, remove the attachment from the power unit. In some cases it will be necessary to move the arm to allow removal of the attachment. Refer to the instructions for the specific attachment being used.
10.Place contents (batch feed type). If the attachment is the batch feed type, disassemble per the specific attachment’s instructions and place the contents in a suitable container.
11.Care and Cleaning.
Once you have completed working with the Bosch Kitchen Machine, the next step is to disassemble and clean the attachments. If you wish to use another attachment, please return to step 4, above.
Power unit
With the power unit turned off and unplugged, it should be cleaned only with a clean, damp cloth. Then wipe off the motor
9
